Download Print this page

RCN RC3544201/01BR User Manual

Table of Contents

Download this manual

User guide for Remote Control RC3544201/01BR

The remote control has been programmed to control your set-top box and can be programmed

to control your TV.

Installing Batteries

The remote requires 2xAAA batteries. A diagram inside the battery compartment of the remote

indicates proper placement of the batteries. When batteries are properly installed, the light on

the remote blinks each time a key is pressed

The diagram below describes each key on your remote control. Functions may vary between

different services. Refer to the user guide for your set-top box for descriptions of specific

functions.

Table of Contents

Do you have a question about the RC3544201/01BR and is the answer not in the manual?

Page 1 User guide for Remote Control RC3544201/01BR The remote control has been programmed to control your set-top box and can be programmed to control your TV. Installing Batteries The remote requires 2xAAA batteries. A diagram inside the battery compartment of the remote indicates proper placement of the batteries.
Page 3 Product Introduction 1) As default, LED will give a confirmation blink when batteries insert. 2) As default, STB control medium is set as STB-RF mode. 3) As default, volume keys (“VOL+/VOL-/MUTE”) are in STB-RF mode. 4) The default TV DB code-set ID for TV IR keys is 0618. 5) The default TV brand ID for blink-out is empty.
Page 4 1. Press <<4 + 6>> simultaneously for 3 seconds. 2. Press the learn key twice quickly (press the key twice within 2 seconds) to clear existing stored learned codes (if any). Reset TV configuration <<1 + 6>>, <9>, <9>, <6> 1.
Page 5 FCC information: FCC ID: 2AGOFRC354C This device complies with Part 15 of the FCC Rules. Its operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Save PDF