Summary of Contents for Trox Technik DID301
- Page 1 OM/US/DID301-302/6 Installation, Operation and Maintenance Manual Active Chilled Beams Type DID301 and DID302...
-
Page 2: Table Of Contents
No part of this document may be reproduced in any form (by printing, photocopying or other means) All rights reserved. or processed, duplicated or circulated electronically without prior written approval by TROX GmbH. DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) -
Page 3: General Information
1.3 below. The DID301 and DID302 active chilled beams are designed for All TROX products are inspected and tested prior to shipment to dealing with high internal thermal loads using a combination of air ensure the highest quality. -
Page 4: Product Description And Installation Preparation
Water connections Induction grille 2.2 Construction description 4 to 6 sliding hanging brackets The assembly (figure 1) of the DID301 and DID302 consists of: (1) sliding hanging brackets (7) face retention bolts Figure 2 ... -
Page 5: Installation
Separate supports should be provided for adjacent systems components. Installation Example Hanging rod Return Sliding bracket Sliding Hanging Bracket (see above also) Rail System DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) -
Page 6: Air Connections
DID302 2-pipe connnection DID302 4-pipe connnection (can be cold or hot) (Standard Construction) Note: Air duct connection location does not affect coil connection configuration (See submittal for additional information on pipe handings) DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) -
Page 7: Flushing The Water Piping System
Warm water contains less oxygen which can limit venting to some extent. 3.8 Typical active chilled beam installation photos Active chilled beams with 2-way flow shown during installation Active chilled beams - finished installation DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) -
Page 8: Waterside Commissioning
8′ chart label provided on each beam or by calculating the volume by using the formula and tables in section 4.3. 9′ 10′ DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) -
Page 9: Maintenance
6 inches if allowed to drop freely. Use care 5.2 Replacement parts and lower beam slowly until wires are taut. DID301 and DID302 chilled beams contain no serviceable or consumable parts. DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) -
Page 10: Troubleshooting
Measure primary air volume using Primary air volume too low procedure described in section 4.3. Increase air volume design figure. DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) -
Page 11: Representations And Warranties
Customer is solely responsible for assuring that such Products do not so infringe. 1.8. The “Warranty Period” begins on the invoice date, and continues to be in effect for twelve (12) months. DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015) - Page 12 U.S. Edition - 2015 DID301-302 Installation, Operation & Maintenance Manual TROX USA, Inc. 4305 Settingdown Circle Cumming, Georgia 30028 Phone: 770.569.1433 Fax: 770.569.1435 E-Mail: trox@troxusa.com www.troxusa.com DID301-302 Installation, Operation & Maintenance Manual (USA) (06/2015)
Need help?
Do you have a question about the DID301 and is the answer not in the manual?
Questions and answers