AVL 16 inch Workshop Dobby Loom User Manual page 39

Workshop Dobby Loom User's Manual
Remove the IDU and disassemble the frame
1) Unclip the left and right Treadle Cables from the IDU.
2) Unscrew the four wing nuts holding the IDU to the X-Frame.
3) Lift the IDU out of the X-Frame and place on the ground on its
rollers. It is now ready to roll.
Figure 39 - 16" WDL with beams tied in place
4) Loosen the two outside stop collars on the Treadle Rod. Remove the
Treadle Assembly from the X-Frame.
5) If you need to break down the Treadle Assembly further for travel,
remove the next two sets of stop collars and remove the Treadles.
Note:
Always leave the inner stop collars on the Treadle Rod to avoid having to
adjust these at re-assembly.
Traveling With Your Workshop Dobby Loom
Traveling with the WDL
Page | 35