Table of Contents
Advertisement
FAN BLADES
Do not clean or repair this product while the fan is running or the unit is plugged in.
Clean the fan blades 2 times a year or more as needed. There are
two fans on this unit, the ventilating fan located on the burner and the
cooling fan. Clean each fan blade with a wet cloth. Be careful not to
break or damage the blades. Allow the fan blades to completely dry
before assembling and using them.
NOZZLE
The nozzle should be cleaned or exchanged once a year as
needed. If contaminated fuel has be used, clean or replace the
nozzle immediately. To clean the nozzle, take it out of the burner,
disassemble then soak in kerosene or gasoline.
SPARK PLUG
Clean and regap the spark plug after every 600 hours of use or as
needed. Remove the spark plug from the burner and clean with an
iron brush. Electrode space should maintain the distance of 3.5 to
3.7mm.
PHOTOCELL
Clean photocell annually or as needed. Clean photocell lens with
cotton swab dipped in alcohol.
LONG TERM STORAGE
1. Open the fuel cap and remove the fuel.
2. Clean the inside of the tank with kerosene or gasoline. DO NOT
USE WATER! Water will cause rust.
3. Completely dry the tank.
Never store this unit with fuel in the tank. Long stored fuel causes
damage to this unit. Make sure storage place is free of dust and
corrosive fumes. Store unit in a well ventilated area. Store the heater
in the original box with the original packing material and keep user's
manual with heater.
Warning:
-7-
fan blade
fan blade
Photocell
Advertisement
Table of Contents
