Wellborn Cabinet DSS Installation Instructions

SS
(1) DRAWERS W/GUIDES ATTACHED
(4) C2312—PLASTIC MOUNTING BLOCKS
(1) C2145—LH CABINET MEMBERS
(1) C2147—RH CABINET MEMBERS
(8) B7934—11.5mm EURO SCREWS
(4) B7905— #8 X ⁄ " TRUSS HEAD SCREWS
5
8
Instructions for installation in single door and butt door base cabinets and utility cabinets
1. Before beginning installation, check to be sure that all of the components are present and read
the instructions thoroughly. It will be necessary to remove the adjustable shelf when installing
the SS & DSS.
2. Position the mounting blocks at the desired locations, (1) in the front set of holes and (1) in the
rear, by inserting the peg on the block into a shelf clip hole. Generally, when installing the SS &
DSS, (1) drawer is located as close to the cabinet floor as possible. Secure the mounting blocks to
the end panels using (1) 11.5mm EURO screw* and (1)
* Note: To prevent stripping, it is recommended that a POZI tip screw driver not a screw gun be used to install Euro
Screws. If a POZI tip is not available, a standard phillips screw driver will work if used carefully.
3. Position the appropriate cabinet members on the sets of mounting blocks and secure, front and
back, using the 11.5mm EURO screws (see detail).
4. Install the drawer unit(s).
Base Cabinet With Center Frame Mullion
When installing in a cabinet with a center frame mullion, we recommend that you purchase a "CMK"—
Center Mullion Kit. It is specifically designed for this application. Simply follow the instructions
included with the kit.
Wellborn Cabinet, Inc. • 38669 Hwy. 77 • P. O. Box 1210 • Ashland, AL 36251 • Phone (256) 354-7151 • FAX (256) 354-7022
I
NSTALLATION
24" S
LIDING
D S
EEP LIDING
KIT INCLUDES:
11.5mm EURO
Screw
#8 x 5/8" Truss Head
Screw
11.5mm
EURO
Screw
I
NSTRUCTIONS
S (SS)
HELF AND
S (DSS)
HELF
(2) DRAWERS W/GUIDES ATTACHED
(8) C2312—PLASTIC MOUNTING BLOCKS
(2) C2145—LH CABINET MEMBERS
(2) C2147—RH CABINET MEMBERS
(16) B7934—11.5mm EURO SCREWS
(8) B7905— #8 X
⁄ " truss head screw per block (see detail).
5
8
C2312 - Plastic
Mounting Block
Mounting
Block
Cabinet
Member
DSS
⁄ " TRUSS HEAD SCREWS
5
8
B7934 - 11.5mm
EURO Screw
B7905 - #8 x 5/8"
Truss Head Screw
B7934 - 11.5mm EURO Screw
N1089 (Rev. 04/2008)