Advertisement
I
NSTALLATION
FOR BASE CABINETS WITH CENTER FRAME MULLION
Front is longer
than back (approx. 1 1/2")
Locate (2) Top/Bottom Plates and determine the front of each by checking the distance from the end to
the groove. It is approximately 1
Assemble the framework by inserting the ends of the Vertical Sticks into the grooves in the Top/Bottom
Plates and installing (4) screws into the predrilled holes located in each end of the Top/Bottom Plates.
Determine the location for each rollout and follow the instructions included with the kit for installing
the C2312 Rollout Brackets and the drawer slide cabinet members to the cabinet end panels and the
Center Mullion Kit. The C2312 Rollout Brackets and drawer slides should now be installed on the
interior of the cabinet end panels and in corresponding locations on the Center Mullion Kit framework.
Position the Center Mullion Kit assembly in the center of the cabinet directly behind the cabinet frame
mullion. DO NOT FASTEN TO THE FLOOR AT THIS TIME.
Install a rollout on each side of the Center Mullion Kit. This will center the kit in the cabinet. Hold the
Center Mullion Kit in place while operating each rollout to make sure they function properly. With the
rollouts in the retracted position, fasten the framework to the floor of the cabinet using (2) #8 x 1
screws.
Wellborn Cabinet, Inc. • 38669 Hwy. 77 • P. O. Box 1210 • Ashland, AL 36251 • Phone (256) 354-7151 • FAX (256) 354-7022
24" S
LIDING
D
S
EEP
C
M
ENTER
Top/Bottom Plate
B7923
#8 x 1 1/4
Flat Phillips Hd.
(4) req'd
Vertical
stick
⁄
" from the front to the edge of the groove.
1
2
S
(SS)
HELF
S
(DSS)
LIDING
HELF
I
NSTRUCTIONS
K
(CMK)
ULLION
IT
Top/Bottom
Plate
(2) Top/Bottom Plate
(6) B7923 - #8 x 1 1/4 FPH Screw
Instructions:
AND
(continued)
C2312 Rollout Bracket
Included with Shelf Kits
B7923 - #8 x 1 1/4
Flat Phillips Hd.
(2) req'd
Parts List
(2) Vertical Stick
⁄
"
1
4
N1089 (Rev. 04/2008)
Advertisement
