Summary of Contents for Battenfeld Hooyman 655237
- Page 1 40V Lithium-ion Battery/Charger Instructions Instructions #1055268 Rev A Product #655237...
- Page 2 BATTERY Specifications 655237 Battery: 40V Max, 73Wh Voltage per cell: 3.6V ; Number of cells: 10 Charge time: 60 min. (Use PB 40V-C Charger) For the proper use, maintenance and storage of this battery, it is crucially important that you read and understand the instructions given in this manual. To avoid serious injury, risk of fire, explosion and danger of electric shock or electrocution: •...
-
Page 3: Checking Battery Capacity
• If leakage gets in your eyes, follow instructions above and seek medical attention. • Please check prior use, if output voltage and current of the battery charger is suitable for the charging battery pack. • Do not use the charger in the circumstances that the output polarity does not match the load polarity. - Page 4 CLEANING Wipe the outside of the charger with a dry, soft cloth. Do not hose down or wash with water. WARNING • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved...
-
Page 5: Battery Charger
WARNING • If a leak develops, the released electrolytes are corrosive and toxic. DO NOT get the solution in the eyes or on skin, and do not swallow it. • DO NOT place these batteries in your regular household trash. •... -
Page 6: Checking The Charger
This is a diagnostic charger. The Charger LED Lights (3) will illuminate in specific order to communicate the current battery status. They are as follows: False Defect Note: When the battery is inserted into the charger, and the status LED flashes, remove the battery from the charger for 1 minute, then reinsert. -
Page 7: Charger Mounting
CHARGER MOUNTING 1. This charger can be installed hanging on a wall using two screws (not supplied) 2. Locate the placement for the charger to be wall mounted. 3. If fastening to wood studs use 2 wood screws. 4. Drill two holes 2 3/8” (6 cm) on center ensuring they are level. 5.