Download Print this page

AWE Tuning 2015+ W205 C300 Installation Manual

Advertisement

Quick Links

Thank you for your purchase of the AWE Tuning 2015+ W205 C300 SwitchPath™ Edition
or Touring Edition cat back
exhaust
system. For up to the minute fitment information, be
sure to visit the W205 C300 section.

Advertisement

loading
Need help?

Need help?

Do you have a question about the 2015+ W205 C300 and is the answer not in the manual?

Questions and answers

Summary of Contents for AWE Tuning 2015+ W205 C300

  • Page 1 Thank you for your purchase of the AWE Tuning 2015+ W205 C300 SwitchPath™ Edition or Touring Edition cat back exhaust system. For up to the minute fitment information, be sure to visit the W205 C300 section.
  • Page 2 1 Allen Key 1 Allen Key 1 SwitchPath™ Remote Kit Installation of the AWE Tuning performance exhaust system is the reverse of the removal OEM exhaust. Always refer to the manufacturer service manual for precise torque specifications on all OEM fasteners.
  • Page 3 (2) 13mm bolts, as shown by Arrow A in Figure 5. With the back end of the AWE Tuning front inlet section supported, reuse the OEM V-band clamp to secure the section to the factory downpipe, as shown by Arrow B in Figure 5.
  • Page 4 Install the 180Technology® mid section (part TW); use the supplied 76.2mm (3-inch) AccuSeal clamp on the expanded sections of pipe and orient away from the chassis. Touring Edition exhaust requires the Mid muffler section (part TV) in place of the 180Technology™ mid section (part TW).
  • Page 5 Instructions for the AWE Tuning SwitchPath™ Edition exhaust installation continue in Step 10. AWE Tuning Touring Edition installation is complete. Enjoy! Disconnect the battery before performing any electrical work. In the trunk, remove the liner to access the harness outlined in Figure 10 (located on the passenger rear corner).
  • Page 6 Underneath the car, locate and plug the harness male connector, at Arrow A, into the SwitchPath™ controller harness’s female connector, at Arrow B in Figure 12. The SwitchPath™ controller harness contains a long branch that will connect to the valve control motor on the driver side tailpipe, route this part of the harness above the underbody bumper panel, shown by Arrow C in Figure 12.
  • Page 7 Use of product in Motorsports or Racing conditions is grounds for warranty denial. Motorsports and Racing is an inherently abusive operational condition, and it is impossible to warranty for this type of usage. Warranties may be voided if product is not installed by an authorized AWE Tuning dealer.