GT-Lite GT-2PK-T8-SLH Assembly & Installation

Assembly & Installation: GT-2PK-T8-SLH | T8 LED Bulb (2pk) Ballast Bypass
IF NOT QUALIFIED DO NOT ATTEMPT INSTALLATION
•Contact a certified electrician to install these bulbs if you are not properly qualified.
Risk of Electric Shock or Fire
•Risk of Electric Shock or is present when working with electrical components.
•Do not drill holes in the fixture that could affect the internal wiring.
Prevent Electric Wire Abrasions
•Do not expose wiring to edges of the fixture or other sharp objects. This can cause
abrasion and damage the wiring, greatly increasing risk of electrical shock or fire.
Fixture Compatibility
•These bulbs are should only be installed in properly bypassed 48" T8 fixtures
•This bulb is only compatible with ballast bypass fixtures. The bulb will not operate
correctly with any ballast.
•This lamp can be used with shunted and non-shunted lamp holders, but requires different
wiring schematics for each type of lampholder
•It is your responsibility to ensure that your fixture has been properly wired for this bulb.
If you are unsure, contact a qualified electrician or contact manufacturer.
Question/Comment/Missing Part?
Complete LED Lighting Solutions
▫ When using product, basic precautions should always be followed.
▫ Read and follow these instructions and heed all warnings.
▫ Carefully read and understand the information given in this manual
before beginning installation. Failure to do so could lead to electric
shock, fire, or other injuries which could be hazardous or even fatal.
▫ Save these instructions and warnings.
BALLAST
BYPASS
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK,
SHUT OFF POWER BEFORE
INSTALLING OR SERVICING THIS FIXTURE
Compatible With:
SHUNTED
LAMPHOLDER
NON-SHUNTED
LAMPHOLDER
Contact GT-Lite 1-800-865-6799
www.GTLEDLIGHTING.com