Page 1
Having issued this warning ICELED Will not accept any responsibility for issues arising from any failure to comply with this clear instruction. ICELED Will not accept responsibility for any other issues arising from improper use or fitting of this product as these matters are beyond our control.
Page 2
Fully waterproof Installation MATRIX may be attached to any flat surface using the adhesive pad on the back of the unit. The surface must be clean and dry prior to application of the adhesive pad. It is therefore advisable to de-grease the surface with Isopropyl Alcohol or similar to obtain the best bond (making sure to observe proper usage instructions for the cleaning agent used).
Page 3
Stand-alone operation If ICELED data is present when the device is powered-up it will produce the colours commanded by the controller. If no data is present when the power is applied,...
Use in 24V electrical systems may be restricted to standalone mode as built in. ICELED controllers are currently only available for operation at 12V. ) UFO controllers produce Global ICELED data that complements the tube data. Additional resources To see the full ICELED product range visit http://www.iceled.co.uk - the official ICELED website.