We are very pleased that you have demonstrated your confidence in us by purchasing this product and we will do our utmost to meet your expectations. Logosol has been manufacturing sawmills since 1989, and in that time we have supplied approximately 50 000 machines to satisfied customers the world over.
EXPLODED VIEW Below, the components are described to assist in identifying them during assembly. Felling bar Square tube with foot Lifting spike Winch attachment Winch Handle Transport latch...
TREE PUSHER/LOG LIFTER COMPONENTS Check that all components are included in the shipment. Square tube with foot Felling bar Manual Winch attachment Lifting spike Bolt bag Winch Bolt bag Assembly instructions...
1. Lifting a log end from the ground. Remove the felling bar for this application. Drive the spike into the log end by swinging the tree pusher/ log lifter against it. Never lift higher than 1 m (3 ft.), and never lift heavier than 500 kg (1102 lbs).
TREE PUSHER/LOG LIFTER ASSEMBLY Fit the lifting spike to the square tube with foot. Fit the winch to the winch attachment. Hex bolt M8x25 Lock nut M8 Washer M8...
Page 8
ASSEMBLY Fit the handle and the transport latch to the winch attachment. Fit the winch assembly to the top of the square tube. Do not tighten the bolts completely. Allen bolt M8x16 Adjusting bolt M8x30...
Page 9
TREE PUSHER/LOG LIFTER ASSEMBLY Pass the felling bar through the winch attachment. Using the adjusting bolt, adjust the angle of the winch attachemnt until the felling bar and the lifting spike runs smoothly up and down along the square tube. Then tighten the top bolt.
Page 10
ASSEMBLY Thread the shackle through the loop in the strap. Fit the shackle in the hole above the spike and secure it with the shackle bolt.
TREE PUSHER/LOG LIFTER TRANSPORT LATCH When transporting: Activate the transport latch and lock it with the rotable handle. Tip: Release the lifting strap and use it as a shoulder strap.