1999-2007 FORD F-250/F-350 6.0/7.3L
BILL OF MATERIALS:
14
15
READ INSTRUCTIONS
WEAR SAFETY
THOROUGHLY BEFORE
GLASSES
INSTALLING PRODUCT
MAGNAFLOW RECOMMENDS PROFESSIONAL INSTALLATION ON ALL THEIR PRODUCTS
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle's
exhaust system to cool before removal, as exhaust system temperatures may cause severe burns. If working
without a lift always consult vehicle manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
ATTENTION: Always install any supplied band or U-bolt clamps to the proper torque specifications of 40-45
ft-lbs for band clamps and 30-35 ft-lbs for U-bolt clamps. Over tightening will result in the clamp breaking and
will NOT be warranted by MagnaFlow.
MAGNAFLOW: 1901 Corporate Centre Drive - Oceanside, CA 92056 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: moreinfo@magnaflow.com
PART NO. 18941
3
2
13
12
9
10
8
SHOP SUPPLIES:
To ease removal of existing exhaust components
(especially on older vehicles) spray penetrating lubricant
on all fasteners and hangers/insulators that will be
loosened or removed and let soak before disassembly.
MINIMUM REQUIRED TOOLS:
Hanger Tool
15mm
(Or Pry Bar)
1
4
5
7
6
11
SPRAY LUBRICANT
Cutting
Device
1. INLET PIPE ASSY. 6.0L
2. INLET PIPE ASSY. 6.4L
3. INLET PIPE ASSY. 7.3L
4. INLET PIPE LOWER ASSY
5. INLET EXTN PIPE ASSY
6. EXTN PIPE 4.00x9.00"
7. PIPE/FLANGE ASSY.
8. ADAPTER 3.50/5.00x7.00"
9. ADAPTER 4.00/5.00x7.00"
10. MID EXTN PIPE ASSY
11. EXTN PIPE 5.00x51.00"
12. EXTN PIPE 5.00x30.00"
13. EXTN PIPE 5.00X18.00"
14. OVER AXLE PIPE ASSY.
15. TAIL PIPE ASSY.
HARDWARE KIT:
1. [1] 3.50" Clamp
2. [3] 4.00" Clamp
3. [5] 5.00" Clamp
4. [1] Hanger Clamp #1
5. [1] Hanger Clamp #2
6. [1] Hanger Clamp #3
7. [1] Hanger Clamp #4
8. [1] 4.00" U-Bolt
9. [2] Nut Hex 3/18"
18941 11/16/16 REV 000