Table of Contents
Advertisement
MW24-1100 MICROWAVE OVEN
Turntable Tray and Turntable Support
The collar at the bottom center of the turntable support
is placed onto the shaft of the turntable motor. The
turntable tray sits on top of the turntable support.
To remove the turntable tray, lift it off of the support and
out of the oven cavity.
(See Figure 4-1)
To remove the turntable support, lift it straight up off of
the turntable motor shaft and out of the oven cavity.
(See Figure 4-1)
Choke Cover
The choke cover has a series of plastic tabs around its
backside that fit into slots in the outer edge of the door
panel.
To remove the choke cover, open the door and insert a
putty knife into the gap between the choke cover and
the door frame. Then, work the putty knife around the
entire choke cover while prying it off of the door panel.
(See Figure 4-2)
Latch Head and Latch Spring
The latch head spring is attached between a hook on
the latch head and a hook on the backside of the door
frame. The pins on the latch head then fit down into
tabs with holes on the backside of the door frame.
To remove the latch head and latch head spring, the
choke cover will need to be removed first. Then, pull
the latch head straight up until the pins disengage the
holes in the tabs. Pull the latch head forward slightly,
then down until the latch head spring disconnects from
the hook on the backside of the door frame.
Figure 4-3)
Tray
Support
Figure 4-1. Turntable Tray & Support Removal
Choke Cover
Door
Frame
(See
Door
Frame
Latch Head and
Latch Head Spring
Figure 4-3. Latch Head & Spring Removal
4-3
Component Removal
Figure 4-2. Choke Cover Removal
#814888 - Revision A - May, 2009
Hide quick links:
Advertisement
Table of Contents
