Volume Control For Earbud; Testing The Scanner - White's MATRIX 100 Instruction Manual

Volume Control for the Earbud
Press the volume control to cycle through the volume levels of low, medium,
or high.* The unit will beep or vibrate and will flash the red visual indicator
LED to announce the new volume level:
One beep/vibration/flash = low volume
Two beeps/vibrations/flashes = medium volume
Three beeps/vibrations/flashes = high volume
When the earbud is plugged into the scanner, the audio speaker is deactivated.
When the unit is turned off or the battery is removed, the ear bud volume level
setting is retained in the memory.
* To be determined by administration policy and supervisor control.

Testing the Scanner

• Turn on the scanner in the "ON Audio" or "ON Vibrate" mode.
• Pass the scanner over a metal test object to ensure the LED, audio alarm, or
the vibrate alarm are functioning properly. If the battery is fresh or recently
recharged (more than 7V), the LED next to the ON/OFF button will produce
a green light (see Page 8). If the battery is discharged to less than 7V, the
LED will produce a yellow light and it is recommended that you replace the
battery.
De-Sense button
888-778-9010
Earbud volume
Sensitivity
10 www.whiteselectronics.com
Stylus