Table of Contents
Advertisement
CAUTION: NEVER IGNITE AND / OR RUN THIS HEATER UNLESS THE SHELLS ARE FULLY EXTENDED AND LOCKED
STEP 1
Heater as received out of box. Before lifting outer shell
protect hands. Never grasp bare metal without hand
protection.
STEP 2
Lift outer shell straight up. Care must be taken to
protect hands during lift.
INTO POSITION.
STEP 3
Lift outer shell until all three clips engage slots in lower
shell. When this happens, the screw holes will line up.
Make sure the clip
goes into the slots
in the lower shell
(3 places).
STEP 4
Lock the clip into place with 3 screws as shown. The
heater must not be operated unless the outer shell is
properly extended and fully locked into place.
Lock the shells together
with the clips in place
and with a screw in
each clip (3 screws
total).
5
Advertisement
Table of Contents
