Tuner Reception - Sony CMT-HX7BT Operating Instructions Manual

Hide thumbs Also See for CMT-HX7BT:
Table of Contents

Advertisement

r the
vice
e,
es
s a
vice,
ve
vice
tooth
olume
e,
es
s a
vice,
ve
tem
ol,
Tuner
Severe hum or noise, or stations
cannot be received. ("TUNED" or "ST"
fl ashes on the display.)
 Connect the antenna properly.
 Find a location and an orientation that
provide good reception, and then set
up the antenna again.
 Keep the antennas, SiriusConnect
Home tuner, and AC adaptor away
from the speaker cords and the power
cord to avoid picking up noise.
 Connect a commercially available
external antenna.
 Consult your nearest Sony dealer if the
supplied AM antenna has come off the
plastic stand.
 Turn off nearby electrical equipment.
The system cannot receive satellite
channels at all.
 Check that the XM Mini-Tuner and
Home Dock or the SiriusConnect
Home tuner are connected properly.
 Th e receiving condition is not good.
Move the antenna to the place where
the condition is good.
 Check that you subscribed to the
desired satellite radio service (see page
11).
To change the AM tuning interval
Th e AM tuning interval is factory-preset
to 9 kHz (or 10 kHz, for some areas).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn off the system.
2
While holding down TUNER/BAND
, press /
.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.
CMT-HX7BT.GB.3-095-517-11(1)
To improve tuner reception
Turn off CD player power by using the
CD power management function. By
default, CD power is turned on.
1
Press FUNCTION
repeatedly to
select the CD function, and then turn
off the system.
2
After "STANDBY" stops fl ashing, press
/
on the unit while holding
down /CANCEL
on the unit.
"CD POWER OFF" appears. With CD
player power turned off , disc access
time is increased. To turn on CD
player power, repeat the procedure
until "CD POWER ON" appears.
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the
system to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
Press /CANCEL
2
, DSGX
/
at the same time.
All user-confi gured settings, such as
preset radio stations, SIRIUS Parental
Lock password, timer, and the clock,
are deleted.
and
GB
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents