Packing List Mounting Hardware Mounting Hardware Package 35-50mm door Package 50-65mm door thickness thickness 20mm 70mm 50mm 30mm 40mm 45mm 55mm 70mm...
Page 4
Cautions 1. The default setting of the device allows ANY fingerprint to unlock. 2. Please register at least one administrator for the newly installed lock. Without administrator, no registration for any normal user is allowed. 3. The lock is equipped with mechanical keys for manually unlocking. Please keep the mechanical keys in a safe place.
Door Preparation 1. Check door thickness, prepare the mounting hardware package and cylinder. Door Thickness D Spindle Length N Screw Length L Screw Length Q Screw Length E Cylinder Length (mm) (mm) (mm) (mm) (mm) (mm) 35-50 50-65 65-80 Note : The standard lock includes 2 mounting hardware packages only, which are used for the door thickness of 35-50mm and 50-65 mm separately.
Page 6
2. Check door open direction. Left inward Right inward Left outward Right outward Note 1: There are 2 types of mortise (F): one is for left open, the other is for right open. Please use the correct one. Note 2: There are 2 types of strike plate (I): one is for inward open, the other is for outward open. Please use the correct one.
Installation 1. Drill holes on the door. Installation door thickness door thickness Template 35~80mm 35~80mm center line of the handle desired handle height Indoor Outdoor Indoor Outdoor Note 1: Align the template along the vertical center line of the mortise (F) at the desired handle height, and tape it to door.
Page 9
4.Install spindle(D). 3.Install lock cylinder(E). Indoor Outdoor Indoor Outdoor Indoor Outdoor Indoor Outdoor Note: Ensure the dot of clutch is vertically Note: Install lock cylinder in right direction, upward. then tighten screw (H) to fix it.
Page 11
6. Install mounting plate (K) with 7. Install spindle (D) on the door. gasket (C) on the door. Indoor Outdoor Indoor Outdoor Indoor Outdoor...
Page 12
8. Install indoor unit (M). 9. Install the battery (O). Indoor Outdoor Indoor Outdoor Indoor Outdoor Note: Push cable into the hole .
Page 13
10.Mark and drill holes for striking. 21mm 15mm (Depth) 16.5mm 27.5mm...
Page 14
11.Test the lock by mechanical key(A) or registered fingerprint. Remove the cover on the key Insert the key into key hole hole with screwdriver or nails. and rotate 90°. Note: AB key system (please refer to the explanation below) is available for this model, if you need this function, please contact the sales.
Need help?
Do you have a question about the TL400B and is the answer not in the manual?
Questions and answers