Jaycar MB-3527 Operating Instructions

AUTOMATIC BATTERY CHARGER FOR
6/12/24V SEALED LEAD-ACID
BATTERY
IMPORTANT SAFETY INSTRUCTIONS:
1. Before charging, read instruction.
2. This charger is intended for use with Lead Acid
rechargeable batteries only. Attempting to
charge other types of batteries may cause
personal injury and damage to the charger.
3. Do not expose charger to rain or moisture. For
indoor use only.
4. Remove from mains when not in use.
5. Never use an extension cord or any attachment
not recommended by manufacturer, otherwise
this may result in a risk of fire, electric shock or
injury to persons.
6. Do not operate the charger if it has been
subjected to shock or damage. Take it to a
qualified serviceman for repair.
7. Do not disassemble the charger. Incorrect
reassemble may result in a risk of electric shock
or fire.
8. Unplug the charger from outlet before attempting
any maintenance of cleaning.
9. This charger is intended to be correctly
orientated in a vertical or floor mount position.
10. During charging, the battery must be placed in a
well ventilated area.
11. This appliance is not intended for use by
persons (including
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
12. Children should be supervised to ensure that
they do not play with the appliance.
children) with reduced
SPECIFICATION:
Input: 100-240VAC 50/60Hz
Output: 6V/ 12V/ 24V DC 1.2A
Battery Type: 6V 8-12Ah, 12V 8-12Ah, 24V 8-12Ah
Lead Acid rechargeable battery.
No. of battery: One battery per charge
OPERATING INSTRUCTIONS:
1. Connect the charger's clips to the battery: Red
pin to positive(+) terminal, Black pin to negative(-)
terminal. Do not allow clips to touch each other.
2. This charger features voltage auto detect
technology and will automatically adjust to
accommodate either a 6V, 12V or 24V
rechargeable lead acid battery. The LED
indicates the battery charging status.
- Red LED lights on – proper charging;
- Green LED lights on – Battery gets fully charged
and ready for use
- Flashing Red LED– Short circuit, reverse polarity or
battery voltage is too low to charge
3. The charging time for 6V/12V/24V 12Ah lead-acid
battery takes approximate 18 hours.
4. Unplug charger from wall outlet and unclip battery
from charger when charging is complete. Never
disconnect charger from battery by pulling on the
wires.
Model: MB-3527