Advertisement
There are 3 operating modes You can use, but only one at a time.
In parallel with the currently active mode, there are always
working
expression pedal ports
feature.
Its purpose is to change the program/patch in Your controlled
device. The buttons act as follows:
-
"UP" and "DOWN":
• When in 'normal' sub-mode: change the displayed program. On each change, the currently
selected program is sent by MIDI.
• When in 'search' sub-mode: change the displayed program. Hold buttons for fast
increment/decrement.
-
„ACT":
• in 'normal' sub-mode: enter 'search' sub-mode. Display starts to blink.
• in 'search' sub-mode: exit 'search' sub-mode and transmit currently selected program by
MIDI. Display stops blinking.
Like 'Basic' mode, plus You may use the "ACT" button to control the tempo in the controlled device.
- "UP" and "DOWN":
• When pressed - enter 'search' mode (display starts to blink) and change the displayed
program. Hold buttons for fast increment/decrement.
-
„ACT" when pressed:
• if in 'search' sub-mode: exit 'search' sub-mode and transmit currently selected program by
MIDI.
• If in 'normal' sub-mode:
- If tap method is "CC message": a CC message is emitted. BPM value is not shown by MIDI
Ant (it's calculated by the controlled MIDI device).
or
- If tap method is "MIDI Clock":
- 2 taps start transmission of MIDI clock stream with 'hard-coded' BPM (only if configured) or
with currently selected BPM by external expression pedal (only if plugged).
- 3 or more taps will start transmission of MIDI clock stream with tapped BPM (only if the
stream is stopped), otherwise taps will adjust the tempo to the interval between the last 2 taps.
Maximum tap interval = 3 seconds (20 BPM)
Minimum tap interval = 0.2 seconds (300 BPM)
After first 24 MIDI Clocks (that is one quarter note), a MIDI Start command is sent.
-
Button „ACT" when hold for 2.3 seconds: only if MIDI clock stream is running, stops it and transmits
MIDI Stop command.
NOTE: The operating modes are active one at a time; only sub-modes can be changed dynamically. See
chapter 'Settings'
to learn how to change operating modes.
NOTE: The tap method can be changed only by the configurator utility program for Windows®.
www.kae-systems.com
and the
Operating mode > Basic
Operating mode > Tap-tempo
Operation
'Message reactor'
- 2 -
MIDI Ant user's manual v5.0
Advertisement
