CamDo ShootX Setup Manual

Setup Guide For CamDo's ShootX Camera
For ShootX Firmware v1.2.1: Camera setup may differ for other firmware versions.
How to start a TimeLapse and download the footage
To change the image settings, adjust the schedule (default of one image every 10mins), frame the camera's view, or enable CloudX features,
Fully charge the camera battery:
Before deploying, fully charge ShootX via the supplied USB cable.
When fully charged, the Battery Status LED changes from red to
green. For the initial charge, this could take up to 24 hours.
USB power can remain connected to ShootX while capturing time
lapse images.
1
End the Time Lapse capture mode:
Once your time lapse has been completed, push the button until
Status Indicator LED turns green and release the button. The LED
will flash red five times before turning yellow to indicate the time
lapse has ended and ShootX is now in "standby mode".
3
Access the ShootX camera from your computer:
Open up your File Explorer, such as My Computer (PC) or Finder
(MAC), and open the device named TIMELAPSE.
5
Eject the camera for safe removal:
Ensure to use the operating system's "Eject" function to unmount
the device before unplugging ShootX to prevent corruption of the
SD card.
7
1) 120° wide angle lens
2) USB Micro-USB Connector*
3) Battery Charging Indicator (LED)
4) Camera Status Indicator (LED)
5) Power/Mode Button
6) Tripod Mount (1/4"-20)
7) Mounting Slot
*only use the supplied USB cable which has an extra long
connector tip for a solid connection with the camera.
refer to the other side.
Start the Time Lapse capture mode:
Push the button until the status indicator LED turns green, then let
go. The status indicator LED will flash green five times to indicate
the camera is now on in time lapse mode. Every time an image is
captured, the LED will also flash green once and will flash blue if
connecting to WiFi to upload to CloudX.
2
Connect ShootX to a Computer via USB:
When ShootX is "standby mode", it will broadcast a WiFi Access
Point (see other
USB cable for downloading the footage.
When connected to a computer, the LED will change from yellow to
white, indicating that the device has successfully mounted.
4
Save and Remove images from the ShootX camera:
Images will be stored in the Timelapse folder, where each separate
sub-folder is timestamped to indicate the start of each time lapse
session. Cut and paste the timelapse folders to your storage device.
6
Turn Off ShootX:
To turn off your camera, press the button for another two seconds
until the LED changes red. When the button is released, the LED
will go dark, indicating the camera is now off.
8
side) and can be connected to a computer with the