Figure 16 Connecting The Flex Extender - Motorola Astro XTS Instruction Manual

38
6. Arrange the console on the bench so that the back housing/PCB
assembly is to the left and the front housing/chassis assembly is
on the right, with the chassis facing upwards. Ensure that the
power, microphone, and speaker cables do not pull on the back
housing/PCB assembly by securely fastening them to the
workbench.
Note: Be extremely careful while performing the next step.
Flexible circuit boards and ZIF connectors are easily
damaged if mishandled.
7. Connect the ZIF connector end of the flex extender (part of
NTN8982_) to the exposed end of the ZIF flex as shown in Figure
16. Hold the end of the flex circuit ribbon so that the text "THIS
SIDE IN" faces upwards, and insert the end into the ZIF
connector. Secure the flex circuit ribbon end by pushing down on
the ZIF connector frame.

Figure 16 Connecting the Flex Extender

8. While holding the flex extender in place as shown in Figure 17,
place the troubleshooting rear housing (second part of
NTN8982_) on the XTVA front cover/chassis assembly. Make sure
that the flex Extender is securely held in place by the
troubleshooting rear housing.
9. Insert and torque the five back cover screws to 8 in-lb using a T-15
TORX driver.
10. Lift the front cover/chassis assembly and gently press the purple
pocket release button to disengage and extend the pocket.
Flex
Extender
Flex
Circuit
ZIF Frame
Fig16