SAFETY WARNINGS AND GUIDELINES These speakers are intended for indoor use only. Do not expose these speakers to water or moisture of any kind. If operating these speakers in a humid environment, ensure that no condensation occurs. Condensation could cause damage to the speaker cones and voice coils. ...
20mm recess pure Titanium dome tweeters 8-ohms nominal impedance Removable and paintable magnetic grilles Spare square magnetic grilles (models 35459 and 35460 only) CUSTOMER SERVICE The Monoprice Customer Service department is dedicated to ensuring that your ordering, purchasing, and delivery experience is second to none.
Please take an inventory of the package contents to ensure you have all the items listed below. If anything is missing or damaged, please contact Monoprice Customer Service for a replacement. Model 35459 2x 6.5-inch in-ceiling speakers with installed round magnetic grilles 2x Square magnetic grilles...
Models 35462 2x 8-inch in-wall speakers with installed square magnetic grilles 1x Installation template 1x L-shaped installation tool 1x User's manual IN-WALL VERSUS IN-CEILING SPEAKERS In-Wall and In-Ceiling speakers are identical in concept and differ only in their form. Wall speakers are traditionally square, like windows and doors, while ceiling speakers are traditionally round, like light fixtures.
SPEAKER WIRE PREPARATION Before attempting to make any connections it is best to look at the situation, get all the necessary materials together, and then make all the connections at once. First, look at the back of your amplifier or receiver to determine what options it offers for making connections.
Positive Negative Black Copper Silver ╋ ╋ ╋ ━ ━ ━ In many cases, the mark is a single stripe on the jacket of one of the connectors. In this case the side with the stripe is generally considered the positive side, but it really does not matter as long as you are consistent and always use the stripe as positive or always use it as negative.
INSTALLATION Perform the following steps to install the speaker onto a wall or ceiling composed of drywall. Note that most of the same procedures apply to ceiling installations. The speaker can be mounted to a surface that is between 1.2" and 1.7" thick, with at least 3.7" internal clearance.
Page 10
11. Route your speaker wire from the back of your amplifier, through the wall or ceiling, to the installation location. 12. If you have not already done so, completely remove the grille, which is held in place with magnets for ease of removal. 13.
SPEAKER REMOVAL Perform the following steps to remove the speaker from its installed location. 1. Pull the edge of the magnetic speaker grille to remove it from the speaker frame. 2. Insert the 6mm hex wrench end (labeled detach) of the included L-shaped installation tool into each hole on the speaker frame.
In-Wall Speakers Model 35461 35462 Speaker Type 2-way in-wall speakers 2-way in-wall speakers Nominal Impedance 8 ohms 8 ohms Woofer Driver 6.5" Dupont™ Kevlar® fiber 8" Dupont™ Kevlar® fiber 20mm recessed pure 20mm recessed pure Tweeter Driver Titanium dome Titanium dome 50 watts RMS 80 watts RMS Power Handling Capacity...
Page 14
Caliber™ is a trademark of Monoprice Inc. DuPont™ and Kevlar® are trademarks or registered trademarks of E.I. du Pont de Nemours and Company or its affiliates.