MBTelehealth –TeleSteth TABLE OF CONTENTS EQUIPMENT REQUIRED ....................3 SET UP..........................3 CONNECTING THE PATIENT SITE ...................4 CONNECTING THE PROVIDER SITE ................5 INSTRUCTIONS FOR USE ....................6 Chestpiece Buttons and Indicators .................7 Selecting a Filter......................7 Adjust Sound Amplification .....................7 Placement Indicator Diagram ..................8 Battery Replacement .......................9...
A Littman 3200 Electronic Stethoscope A Wireless Bluetooth Dongle SET UP To set up the TeleSteth Application and the Littman 3200: 1. Connect an Ethernet cable from the laptop to port FE1 on the Cisco router or if there is no router present, plug the Ethernet cable into the identified drop on the...
MBTelehealth –TeleSteth Turn on the Stethoscope by pressing the power button Power Double click the TeleSteth Icon on the laptop to launch the application Note: It may take between 30 and 60 seconds to open. Be patient 6. Enter the user name and password located on the bottom left hand corner of your laptop.
MBTelehealth –TeleSteth Read the Session ID to the Provider The provider can use this diagram to give direction on placement of the stethoscope on the patient 3. Once connected, watch the placement indicator (white dot) for placement instructions from the provider.
MBTelehealth –TeleSteth Once connected, click on Join a Session then enter the Session ID provided by the patient site and press Join Ensure the Audio Mode is set to Play to Stethoscope Note: If Play to Stethoscope is not already selected, click the radio button to select Once connected, use the white dot to provide placement instructions for the patient site (see 5.4 for instructions for use).
MBTelehealth –TeleSteth 5.1 Chestpiece Buttons and Indicators 5.2 Selecting a Filter The electronic stethoscope allows the user to select between three different digital frequency filters to better emphasize the specific patient sounds of interest. Filter settings are adjusted by the provider and are not dependent on the facilitator at the client end.
MBTelehealth –TeleSteth 5.4 Placement Indicator Diagram The Zargis software includes an option for identifying the desired location of the stethoscope. By clicking on the model, a provider can indicate to the patient site the exact location the want the stethoscope to be placed. Clicking in the desired location moves the white dot to that location on both the provider and patient site displays.
MBTelehealth –TeleSteth Note: See below for recommended location for holding the stethoscope while in use. 5.5 Battery Replacement 5.6 Position Headset Eartips should point in a forward direction as you insert them into your ear canals. When ear tips are properly positioned, diaphragm will face towards your body. Your new 3M™ Littmann®...
MBTelehealth –TeleSteth 5.7 Adjust Headset for Comfort To reduce spring tension in the headset, hold each eartube at the bend near the eartips and gradually pull apart until fully extended (180 degrees). To increase spring tension, grasp the headset with one hand where the metal eartubes enter the plastic tubing, and squeeze until the plastic tubing on one eartube touches the other.
Page 11
MBTelehealth –TeleSteth 4. Ability to examine from right side. [This decreases the Diagram A likelihood of producing extraneous sounds from the tubing of the stethoscope hitting objects.] 5. A stethoscope with both a bell and diaphragm or capacity to act as a bell and diaphragm. [The bell when held lightly against the chest picks up sounds of low frequency.
Need help?
Do you have a question about the Littman 3200 and is the answer not in the manual?
Questions and answers