Download Print this page

Ops-Core NVG Snap Shields Operator's Manual

For use with an/pvs-15 (m953) night vision binoculars

Download this manual

Enlarged version

MAINTENANCE

CLEANING AND CARE

1. Spot-clean with a mild detergent and water.

2. Visually check the entire Snap Shield for signs of wear or breakage.

3. Clean dust and dirt by using air pressure.

NVG SNAP SHIELDS

4. Check that the snap mechanism works properly.

OPERATOR'S MANUAL

NOTE: IF ANY DEFECTS ARE FOUND, THE DAMAGED COMPONENTS SHOULD BE

REPLACED BEFORE USE.

UM-1021 REV. A

For use with AN/PVS-15 (M953)

Night Vision Binoculars only.

Page 1 1. Spot-clean with a mild detergent and water. 2. Visually check the entire Snap Shield for signs of wear or breakage. 3. Clean dust and dirt by using air pressure. NVG SNAP SHIELDS 4. Check that the snap mechanism works properly. OPERATOR’S MANUAL NOTE: IF ANY DEFECTS ARE FOUND, THE DAMAGED COMPONENTS SHOULD BE REPLACED BEFORE USE.
Page 2 PREPARE This manual covers the installation and basic operating instructions for the Ops-Core NVG Snap Shields. The snap shields are designed to fit the AN/PVS-15 Night Vision Press firmly on the release mechanism and pivot Binocular. The snap shields feature a pivot mechanism that snap onto the binocular for secure open the snap shield.