Viking CTG-1 Product Manual page 4

C. Turning the Alert Tones On/Off for Specific Days of the Week
Press the MODE button repeatedly until the SET DAY indicator lights. The current day
Step 1. of the week and "on" or "of" will be displayed. "on" = alert tones are ON and "of" = alert
tones are OFF for that day of the week.
Pressing the SINGLE button will toggle between flashing the day of the week and
Step 2. flashing "on" or "of". The flashing portion of the display is the section that can be
changed.
With the day of the week flashing, use the TIME (+ and -/CANCEL) buttons to select
the day of the week you would like to set to ON or OFF. When the correct day of the
Step 3.
week is displayed, press the SINGLE button to flash "on" or "of". The day can then be
set to ON or OFF by using the TIME (+ and -/CANCEL) buttons.
Review your day of the week programming by pressing the SINGLE button until the
weekday (1-7) is flashing, then increment through each day of the week with the TIME
Step 4.
(+) button and monitor each day for its on or off setting. Exit the SET DAY mode by
simply pressing the MODE button.
D. Setting Timed Alert Tones
Step 1. Press the MODE button repeatedly until the SET EVENTS indicator lights.
Increase or decrease the event time by pressing the TIME (+ or -/CANCEL) button until
Step 2.
the desired time is shown.
Move DIP switch 2 to OFF for bong alert tones or ON for buzzer alert tones (see
Step 3.
Programming section J).
Press one of the single, double, or triple ALERT TONES buttons to program the number
Step 4. of alert tones you wish to output at the specific event time. A single, double, or triple
confirmation beep should be heard.
Step 5. Repeat steps 2-4 for the remainder of your scheduled events.
Note: If more than 128 events have been entered, a long beep will be heard indicating that the
event memory is full.
E. Reviewing and/or Cancelling Timed Alert Tones
Step 1. Press the MODE button repeatedly until the REVIEW/CANCEL indicator lights.
Press one of the ALERT TONES buttons (single, double, or triple) repeatedly to rotate
through the event times associated with that alert tone button. A red LED at the bottom
Step 2.
right corner of the time display will light to indicate a buzzer event time (versus a bong
event). Note: Event times are stored in the order of programming, not chronologically.
Press the -/CANCEL button to permanently cancel an event tone.
Step 3. acknowledgement tone will be heard. The next consecutive event for that specific alert
tone will then be displayed.
Step 4. Repeat steps 2-3 as needed to remove the events to be cancelled.
When all events for a given alert tone have been cancelled, the display shows three
Step 5.
dashes (- - -).
4
A single