Download Print this page

Ace 73-201 Safety & Instruction Manual

Portable fume extractor

Advertisement

Quick Links

CAUTION:
This device is powered by rotating electrical machinery!! Careless or improper use may result in
personal injury. Read the Safety Precautions and Warnings contained within prior to operating this machine.
SAFETY WARNINGS & CAUTIONS
FAILURE TO OBSERVE THE FOLLOWING
PRECAUTIONS COULD RESULT IN SERIOUS
INJURY, INCLUDING DEATH IN EXTREME CASES.
SAVE THESE INSTRUCTIONS.
WARNING: (EXPLOSION HAZARD)
This unit contains universal motors which spark during
normal operation. Do not use in areas contaminated
by volatile or flammable materials as these sparks may
ignite the contaminates and cause a dangerous
explosion.
WARNING: (EXPLOSION HAZARD)
This machinery is not suitable for collection of
combustible metal as listed in NFPA 484, which
includes: Aluminum, Titanium, Magnesium, Lithium,
Niobium, and Zirconium.
WARNING:
(VOC'S & AIRBORNE MICROBES)
The filters used in this unit will remove solid particulate
ONLY, and will not eliminate Volatile Organic
Compounds (VOC's) or airborne microbes (bacteria,
mold & viruses) that may be a health hazard. Failure
to observe the presence of such fumes could cause
serious illness or death.
CAUTION: (SHOCK HAZARD)
To insure continued protection against shock hazard,
connect A.C. cord only to properly grounded outlets.
Replace defective cords immediately. Don't expose to
moisture or liquid as this could defeat the electrical
insulation thus causing electrical shock.
CAUTION: (STRONG VACUUM)
Care must be taken to avoid personal injury by not
allowing hose inlet to contact any body area such as
eyes, ears, mouth, etc.
SAFETY & INSTRUCTION MANUAL
READ AND SAVE THESE INSTRUCTIONS.
ACE INDUSTRIAL PRODUCTS
PORTABLE FUME EXTRACTOR
MODEL 73-201
CAUTION: (LIFTING)
This unit weighs more than 40 lbs. with filters, improper
lifting or handling of this unit could cause back injury.
CAUTION: (AIR FLOW BLOCKAGE)
Since exhaust air leaves the bottom of this unit,
caution should be observed not to set unit down in
such a way as to block the exhaust.
MISCELLANEOUS CAUTIONS:
1. Use of any attachment no recommended or sold
by the air cleaner manufacturer may result in risk of
fire, electric shock, or injury to persons.
2. To reduce the risk of damage to the electric plug or
cord, disconnect by pulling plug rather than cord when
removing power form the air cleaner.
3. Make sure cord and hose are located so they will
not be stepped on, tripped over, or otherwise subjected
to damage or stress.
4. An extension cord should not be used unless
absolutely necessary. Use of improper extension cord
could result in risk of fire and electric shock.
If extension cord must be used, use only a grounded
cord and follow these recommendations:
100 ft. #10 AWG
5. Do not disassemble the air cleaner. Take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in risk of
electric shock or fire.
6. To reduce the risk of electric shock or bodily injury,
unplug the air cleaner from outlet before attempting
any maintenance or cleaning. Turning off the power
switch will not eliminate this risk.
1
25 ft. #14 AWG
50 ft. #12 AWG

Advertisement

loading

Summary of Contents for Ace 73-201

  • Page 1 ACE INDUSTRIAL PRODUCTS PORTABLE FUME EXTRACTOR MODEL 73-201 SAFETY & INSTRUCTION MANUAL CAUTION: This device is powered by rotating electrical machinery!! Careless or improper use may result in personal injury. Read the Safety Precautions and Warnings contained within prior to operating this machine.
  • Page 2 THEORY OF OPERATION UNPACKING This unit is a lightweight, portable air cleaner Carefully inspect the unit for concealed damage that employing two thermally protected, high performance, may have occurred during shipping and handling. If flow through vacuum motors producing very high any damage is found, immediately contact the freight velocity air flow through the unit.
  • Page 3 MAINTENANCE & REPLACEMENT PARTS Figure 2 OPERATION FILTERS: Your Ace Industrial Products machine is designed as a As previously stated in the “Theory of Operation” source capture device, i.e., it is intended to eliminate section of this manual, the “clogged” filter indicator light smoke and particulate at their point of origin.
  • Page 4 ACCESSORIES The following accessories and attachments are Motor brushes are available from the factory by available from the factory or from your Ace dealer ordering Part No. 65007. The use of high performance, ball sleeve motors provide about 500 Flex Tube ..............65012 hours of brush operation (depending upon filter Magnetic Base ............