Sony MDR-1RNC Operating Instructions

Noise Canceling
Operating Instructions
Headphones
MDR-1RNC
© 2012 Sony Corporation Printed in Malaysia
English Noise Canceling Headphones
Using the Center button
WARNING
(Inline remote and
Do not expose the battery to excessive heat such as direct
microphone cord for
sunlight, fire or the like.
iPod/iPhone/iPad)
Checking the remaining
battery Operation Explanation
Single press Plays/pauses a track of the
connected iPod.
Status POWER Indicator Beep sound Double press Skips to the next track.
Full * No beep
Blinks 3 times Triple press Skips to the previous track.
 Blinks 2 times * No beep Long press Starts the "VoiceOver
available).
Low * No beep
Blinks 1 time
Press once when call is Answers the call.
Empty Blinks quickly Long beep
incoming
(30 seconds) (2 seconds)
Press again Ends the call.
* When turning off the power of the headphones.
Hold down for about Rejects an incoming call (two
two seconds and low beeps confirm the call was
release rejected).
Checking the charging
*
Availability of the "VoiceOver" feature depends on iPod
status
and its software version.
Note
Status Charging indicator
Be careful not to unintentionally press any buttons when
Charging On you carry your iPod with this headphones connected.
Full Off
Charging malfunction Blinks
Automatic AI Noise
Canceling
The Automatic AI Noise Canceling function constantly
analyzes environmental ambient sound components and
automatically selects the most effective noise canceling
mode.
Noise canceling mode types
NC Mode A: Noise mainly in an airplane is effectively
reduced.
NC Mode B: Noise mainly in a bus or a train is effectively
reduced.
NC Mode C: Noise mainly found in an office environment
(PC, copier, air ventilation, etc.) is effectively
reduced.
How to use/使用方式/사용 방법
1
Charging the headphones/對耳機充電/헤드폰 충전하기
L indication R indication
L 標示 R 標示
L 표시 R 표시
GB
CT
2
Connecting/連接/연결하기
KR
Tactile dot (on the left)
觸感圓點（在左邊）
돌기(왼쪽)
3
Turning on the power/開啟電源/전원 켜기
Tips Notes on using on the airplane
– When the headphones are turned on, NC Mode A is set.
Do not use the headphones when use of electronic
– It may take a few seconds to analyze the environmental
(1)
equipment is prohibited or when use of personal
ambient sound.
headphones for in-flight entertainment services is
4-434-825-21(1)
prohibited.
Notes on use
Notes on charging the headphones
–
Charge the headphones using the supplied micro-USB
What is noise canceling?
cable. Otherwise, it may cause a malfunction.
– Charge in an environmental temperature of between 5°C
The noise canceling circuit actually senses outside noise
and 40°C. Otherwise, the battery may not fully charge.
with built-in microphones and sends an equal-but-opposite
– If you haven't used the headphones for a long time,
canceling signal to the headphones.
the life of the rechargeable battery may become short.
Notes on the noise canceling function This will improve when you repeat the charging and
discharging process several times.
– Adjust the earpads so that they cover your ears, otherwise
–
Do not store the headphones in hot places for a long time.
noise canceling will not function properly.
When storing it for more than a year, charge the battery
– The noise canceling effect may vary depending on how
once a year to prevent over discharge.
you wear the headphones.
– For system requirements for a computer that can charge
– Do not cover the microphone of the headphones with
the battery using USB, see "System requirements for
your hands. The noise canceling function may not work
battery charge using USB".
* " feature (if properly.
– If the headphones are malfunctioning, charging will not
start and the charging indicator will blink. In this case,
disconnect the unit from the connected device, and
consult your place of purchase, or a Sony dealer.
Notes on handling
– Because the headphones are designed to fit closely in your
ears, forcing them against your ears may result in eardrum
damage. Avoid using the headphones where they are
liable to be struck by people or other objects, such as a
ball, etc.
– Pressing the headphones against your ears may produce a
diaphragm click sound. This is not a malfunction.
Microphone
– Clean the headphones with a soft dry cloth.
– After you turn on the power of the headphones, you may – Do not leave the plug dirty otherwise the sound may be
distorted.
hear a slight hiss. This is the operating sound of the noise
canceling function, not a malfunction. – Be sure to consult a Sony dealer when the earpads
– The noise canceling function works for noise in the low become dirty or damaged, or when the headphones
frequency band primarily. Although noise is reduced, it is require repair work.
not canceled completely. – Do not leave the headphones in a location subject to
– The noise canceling effect may not be pronounced in a direct sunlight, heat or moisture.
very quiet environment, or some noise may be heard. – Do not subject the headphones to excessive shock.
– When you use the headphones in a train or a car, noise – Handle the driver units carefully.
– If you feel drowsy or sick while using this headphones,
may occur depending on street conditions.
– Howling may occur if you do not wear the headphones stop use immediately.
correctly.
Notes on headphones
– Howling may occur if you place an object such as finger
close to inside of the headphones. Keep it away from the
headphones.
– Mobile phones may cause interference and noise. Should
this occur, locate the headphones further away from the
mobile phone.
As headphones reduce outside sounds, they may cause a
traffic accident. Also, avoid listening with your headphones
in situations where hearing must not be impaired, for
example, a railroad crossing, a construction site, etc.
Micro-USB cable
Micro-USB纜線
Micro-USB 케이블
Charging indicator
充電指示器
충전 표시기
Digital music player, etc.
iPod/iPhone/iPad
數位音樂播放器等
iPod/iPhone/iPad
디지털 음악 플레이어 등
iPod/iPhone/iPad
Connecting cord
連接導線
연결 코드
Inline remote and microphone cord for iPod/iPhone/iPad
iPod/iPhone/iPad適用的內嵌遠端和麥克風導線
iPod/iPhone/iPad용 인라인 원격 및 마이크로폰 코드
4
Wearing and controlling/配戴和控制/착용 및 제어하기
Volume+
音量+
볼륨+
Center button
中間按鈕
중앙 버튼
Volume–
音量-
볼륨-
Note on static electricity
In particularly dry air conditions, noise or sound skipping
may occur, or mild tingling may be felt on your ears. This is a
result of static electricity accumulated in the body, and not a
malfunction of the headphones.
The effect can be minimized by wearing clothes made from
natural materials.
If you have any questions or problems concerning the
system that are not covered in this manual, please consult
the nearest Sony dealer.
Troubleshooting
No sound
–
Recharge the headphones. You can use the headphones
while charging.
You can listen to the music using the headphones even
when the POWER switch is set to "OFF". In this case, the
noise canceling function, Digital Equalizer, S-Master and
DSEE are not active, and the headphones operate as
passive headphones.
– Check that the rechargeable battery is not depleted.
– Check the connection of the headphones and the
equipment.
– Check that the connected equipment is turned on.
– Turn up the volume of the connected equipment.
The noise canceling effect is not sufficient
– The noise canceling function is effective in low frequency
ranges such as airplanes, trains, or offices (near air-
conditioning, etc.) and is not as effective for higher
frequencies, such as human voices.
– Turn on the headphones.
Distorted sound
– Turn down the volume of the connected equipment.
– Recharge the headphones.
Power does not turn on or the headphones
do not operate properly
– Recharge the headphones.
If the power does not turn on, even after charging the
headphones, the rechargeable battery may be damaged.
In this case, consult your place of purchase or a Sony
dealer.
High volume may affect your hearing. For traffic
safety, do not use while driving or cycling. Charging cannot be done
– Check that the charging indicator is lights up.
Connect the headphones and the micro-USB cable
securely.
– Check that the micro-USB cable and the computer are
firmly connected.
– Check that the micro-USB cable and the computer are
directly connected; not via a USB hub.
– DSEE
Offers natural sound with a spacious feel by restoring
high-frequency range sound and the tail shape of the
waveform likely to be removed through the audio
compression process.
– Up to 22 hours of listening time
– Passive operation
Allows audio listening even when the headphones power
is turned off.
– Detachable cord
3.5 mm connecting cord, and inline remote and
microphone cord for iPod/iPhone/iPad
Specifications
General
Type Closed, dynamic
Driver units 50 mm, dome type
Power handling capacity
100 mW
Impedance 52 Ω at 1 kHz (when the power is on)
16 Ω at 1 kHz (when the power is off)
Sensitivity 103 dB/mW (when the power is on)
100 dB/mW (when the power is off)
Frequency response
5 Hz – 24,000 Hz
Total Noise Suppression Ratio
Approx. 25 dB
Power source DC 3.7 V Built-in lithium-ion rechargeable
battery or DC 5 V USB
for dual jacks for stereo mini jack
Mass Approx. 330 g (without cord)
適用於雙聲道插孔 適用於立體聲迷你插孔
듀얼 잭용 스테레오 미니 잭용 Talk microphone Open circuit voltage level (Inline remote
and microphone cord for iPod/iPhone/iPad)
–42 dB (0 dB = 1 V/Pa)
Headphones charging and usage time
Approx. charging hours Approx. usage hours
4 hours 4)
Included items
After use
Headphones (1)
Turn off the power of the headphones
Connecting cord (1.5 m cord, using PCOCC, gold-plated
使用後 L-shaped stereo mini plug) (1)
關閉耳機電源 Inline remote and microphone cord for iPod/iPhone/iPad
(1.2 m cord, using PCOCC, four-conductor gold plated L-
헤드폰을 사용한 후
shaped stereo mini plug) (1)
헤드폰의 전원을 끕니다
Microphone Micro-USB cable (1.5 m) (1)
麥克風 Plug adaptor for in-flight use
마이크로폰 Carrying case (1)
Operating Instructions (1)
1) Under the Sony measurement standard.
2) Equivalent to approx. 99.7% reduction of energy of sound
compared with not wearing headphones.
3) At 1 kHz, sound pressure level 90 dB output
4)
Hours required to fully charge an empty battery
5) Time stated above may vary, depending on the
temperature or conditions of use.
6) May not be compatible with some in-flight entertainment
– Check the system requirements for a computer that can services.
charge the battery using USB.
Design and specifications are subject to change without
– Check that the computer is turned on.
notice.
– Check that the computer is not in standby, sleep or
hibernation mode.
–
If the charging indicator blinks, the headphones may be
Compatible iPod/
malfunctioning. Disconnect the unit from the connected
device, and consult your place of purchase, or a Sony
iPhone/iPad models
dealer.
The unit cannot be recognized by a
You can use the headphones with only the following models
computer
supporting remote control. Update your iPod, iPhone or
iPad to the latest software before use. In the Operating
– Check that the micro-USB cable and the computer are
Instructions, iPod, iPhone and iPad are collectively described
firmly connected.
as "iPod" except in special cases.
– Disconnect the micro-USB cable from the computer and
– iPod touch (4th generation)
connect again.
–
iPod touch (3rd generation)
– Check that the micro-USB cable and the computer are
– iPod touch (2nd generation)
directly connected; not via a USB hub.
– iPod nano (6th generation)
– There may be a problem with the connected USB port
– iPod nano (5th generation)
of the computer. Connect to another USB port if it is
– iPod nano (4th generation)
available.
– iPod classic 120GB 160GB (2009)
– Try the USB connection procedure again in cases other
– iPod shuffle (4th generation)
than those stated above.
– iPod shuffle (3rd generation)
No operation works –
iPhone 4S
– iPhone 4
– Set the POWER switch of the headphones to "OFF",
– iPhone 3GS
confirm the connections, and then set the POWER switch
– iPad (3rd generation)
back to "ON".
– iPad 2
– Reset the headphones.
– iPad
Insert a small pin, etc. into the RESET button on the left
housing, and press until the button slightly rebounds.
On copyright
The connected iPod does not work iPad, iPhone, iPod, iPod classic, iPod nano, iPod shuffle, and
iPod touch are trademarks of Apple Inc., registered in the
– Check if the cord is connected correctly. Connect
U.S. and other countries.
the L type plug to the iPod and the other plug to the
"Made for iPod", "Made for iPhone", and "Made for iPad" mean
headphones.
that an electronic accessory has been designed to connect
specifically to iPod, iPhone, or iPad, respectively, and has
Features been certified by the developer to meet Apple performance
standards. Apple is not responsible for the operation of this
device or its compliance with safety and regulatory standards.
– Digital Noise Canceling with Dual Noise Sensor
Technology
Microphones both inside and outside the housings are
combined with digital noise canceling software engine to
deliver significant noise canceling performance.
– Automatic AI (Artificial Intelligence) Noise Canceling
function.
Automatic selection of the optimal noise canceling mode
based on intelligent analysis of environmental ambient
noise.
– Digital Equalizer and full digital S-Master amplifier
Delivers ideal frequency response and high-quality music
reproduction with full digital processing.
System requirements
for battery charge using
USB
Personal Computer with pre-installed with any of the
following operating systems and USB port:
Operating Systems
– When using Windows ®
Windows ® 7
(Home Premium / Professional / Ultimate / Starter)
(including 64 bit version)
Windows Vista ® (Service Pack 2 or later)
(Home Basic / Home Premium / Business / Ultimate)
(including 64 bit version)
®
Windows XP (Service Pack 3 or later)
(Home Edition / Professional / Media Center Edition 2004 /
Media Center Edition 2005)
– When using Macintosh
Mac OS X (version.10.5 or later)
Windows and Windows Vista are registered trademarks or
trademarks of Microsoft Corporation in the United States
and/or other countries.
Macintosh and Mac OS are trademarks of Apple Inc.,
1)
registered in the U.S. and other countries.
2)
3)
22 hours 5)
6) (single/dual) (1)