TAGG AudioSync User Manual

Thank you for purchasing TAGG AudioSync bluetooth receiver. This
bluetooth receiver supports bluetooth standard 4.1 and is compatible
with all smart phones, tablets and laptops and all other AUX
compatible devices. Our goal is to please you with superior sound
quality and comfort combined with convenience of handsfree
operation. Please take the time to read the below information that will
AudioSync
help you operate this receiver properly:
AUX-In Bluetooth Receiver
USER'S MANUAL
Product overview:
AUX -IN
5 4 LED
3
MIC
Power Button
1
2 Micro USB Charging
Receiver controls:
FUNCTION OPERATION
Long Press the Power Button for 3 secs
Power ON
Pairing Mode Blue and Red LED will start Blinking
Long Press the Power button for 3 secs
Power OFF
Connected Blue LED will Blink twice
Answer Call Short press the Power button
End Call Press the Power button for 1 sec
Redial Last Number Short press the Power button twice
Cancel Dialing Short press the Power button
Product features:
It converts your audio device into a wireless music device.
Bluetooth 4.1, Noise Isolation and Built-In rechargeable battery.
Shutdowns under unpaired status for more than 5 minutes.
Built-In microphone ensures clear handsfree calling.
Just plug it in 3.5mm Audio Jack and you are good to go.
Product parameters:
Bluetooth version 4.1 A2DP, AVRCP
B Frequency response: 20Hz - 22kHz
Play time: Up to 5 hrs.
Charging time: Up to 1.5 hrs.
Bluetooth range: Up to 10 meters
S/N: 92dB
Connecting with your device:
Keep your bluetooth device with in 3 ft. while pairing.
Press the power button of AudioSync receiver for 3 secs and
Blue & Red LED will blink. The receiver is now in pairing mode.
Now search for available bluetooth devices in your device and
select TAGG AudioSync from the list of available devices.
If prompted, enter the password or PIN "0000".
If prompted by your mobile phone to connect, click "YES".
After successful connecting Blue LED will flash twice after
every 4 secs.
How to charge:
Connect to the power using Micro USB cable.
To better protect the battery life, kindly use the charging
cable provided with the receiver.
Allow 1-2 hours to completely charge the receiver.
LED Indication:
While charging – Red LED will be ON
When completely charged Blue LED will be ON.
When battery is low, Red LED starts blinking every 4 secs.
Pairing Mode – Blue and Red LED starts flashing.
CALL Instructions:
While there is an incoming call, press the Power button
to connect.
Reject Calls - While there is an incoming call, press the
power button for 1 sec, This will reject the call.
Redial Last Number - For dialing a last number, press the
power button twice.
Cancel Dialing - Short press the power button.