Jump-starting your Vehicle 1. Attach the red Jump-starting clamp to 2. Plug in the jumper cables. the red positive [+] battery terminal, and connect the black clamp to the negative [—] battery terminal. 3. Switch on jump-starter and check 4. Start your engine. it is over 50% charged.
Page 5
Jump-starting your Vehicle For maximum output and product Unplug the jumper cables longevity, wait 30 seconds between within 30 seconds. jump-start attempts. Do not connect the red and black clamps together. If display shows 50% or less, charge jump-starter prior to next use. Failure to do so could result in damage to jump-starter.
Page 6
Knowing the Cables Steady Ready to jump-start. Standby. Cables are plugged into Steady the jump-starter and are now ready to be connected to the battery. 1. Cables are hooked up properly but have not been used for 60 seconds. Please press reset button to be ready.
Page 7
Knowing the Cables Reverse Charging Protection: Vehicle voltage normal, Flashing jump-starting is not necessary. Please seek a service professional for further assistance. Over Temperature Protection: Cables are overheated, allow Slow cables to cool until the red light Flashing reappears. Press reset button prior to next use.
Using the flashlight Press and hold power button for 3 seconds: Steady flashlight beam. Next quick press: SOS Strobe Next quick press: Fast Strobe Next quick press: Turn off flashlight Turn on the main switch...
Page 10
recharging the product Locate the charging port.
Need help?
Do you have a question about the Flex and is the answer not in the manual?
Questions and answers