Advertisement
Advertisement
Table of Contents
Summary of Contents for Strobepro 300II M
- Page 1 STFIOBEPFIOij X (« 1 >> R a dio Str o b e series Instruction Manual...
- Page 2 It's small, compact, fully featured and packs a punch. Make sure you pick up a Strobepro controller to get the full benefit of all this strobe has to offer. Match the channels and group on the flash and controller and you're ready to go.
- Page 4 Using gloves, install the modeling lamp and add your reflector or desired modifier. adjusts (FULL) used to install a photo umbrella. will turn will ing. higher the flash power off Use when using a radio trigger. it sees any other flash in the the sensor.
- Page 5 Error flash settings. 300II M has a built in internal wireless receiver, eliminating the need for an external receiver. In certain situations you may want to use an older XTM and XRM legacy receiver on your strobe. This port can be found on the side of the flash.
- Page 6 Wrap Strobepro. If the strobe gets wet, stop use immediately. 300II M XRM Receiver...
Need help?
Do you have a question about the 300II M and is the answer not in the manual?
Questions and answers