Summary of Contents for cleanAIR BASIC 2000
- Page 1 Clean-air BASIC 2000 Clean-air Basic 2000 Flow Control Clean-air Basic 2000 Dual Flow Instructions for Use This instruction lea et must be read and followed!
-
Page 2: Table Of Contents
For an adequate and effiicient protection it is necessary to choose the correct combination of a respiratory unit, suitable filters and a protective headpiece. Clean-air BASIC 2000 respiratory system meets the European standard EN12 941. It provides protection against non-toxic and toxic particles, solid and liquid aerosols. -
Page 3: Preconditions For Use
Make sure that the air hose doesn‘t make a loop and doesn’t get caught on something in the surrounding. • Respiratory system CA BASIC 2000 is restricted for protection against solid and liquid particles only. Do not use it against toxic gases and vapours. - Page 4 3.3. Usage CA BASIC 2000 DUAL FLOW Switch on the unit by pressing the ON/OFF button on the control panel. There are two arrow-buttons on the switch board: ECO / TURBO. By using the two arrow- buttons it is possible to set the airflow at a lower level (ECO) or at a higher level (TURBO).
-
Page 5: Before Use
The particle filter can be used with a Pre-filter or with an Odour filter which removes the unwanted smell of harmless gases. CHANGING THE FILTER OF CA BASIC 2000 …....see picture supplement no.1 pict. 1A : Removing the filter cover: Face the silver filter cover towards you. Put your index fingers and middle fingers into the gaps between the body of the unit and the filter cover on both sides. - Page 6 Do not leave the charger in the power supply if not in use ! 6.2.2. Battery changing CA BASIC 2000 …....see picture supplement no.3 pict. 3A : Removing the battery: Take the blower unit in both hands facing the rear side of battery towards you.
-
Page 7: Fault Finding
7. Fault finding If there is a sudden change in air supply while using the Clean-air system, it is necessary to check the following: That all parts of the air-supplying system are assembled properly. • The battery and its connector. •... -
Page 8: Technical Data
10. Technical data CA BASIC 2000 CAB DUAL FLOW CAB FLOW CONTROL 160* - 140 l/min 140 to 210 l/min Airflow 200* - 180 l/min (at 8 adjustable flow rates) * with fully charged battery and clean filter Weight of the blower unit incl. the... -
Page 9: List Of Parts
11. List of parts: CA BASIC 2000 Part no.: Description: 800000XP CLEAN-AIR BASIC 2000 DF - complete set blower incl. battery, air hose, belt, charger EN, airflow indicator) 800000XPU CLEAN-AIR BASIC 2000 DF - complete set blower incl. battery, air hose, belt, charger UK, airflow indicator) - Page 10 Picture supplements Changing the filter CA BASIC 2000...
- Page 11 Changing the battery CA BASIC 2000...
Need help?
Do you have a question about the BASIC 2000 and is the answer not in the manual?
Questions and answers