Advertisement
SPA SET UP AND OPERATING GUIDE
Read and Understand All Instructions before operating your Spa.
It is important that your new Spa be installed on a Solid, Flat, and Level Surface that is engineered to carry a load
of 75 pounds per square feet. The proper site of your New Spa is in an area that is Not Accessible to Children.
Security or Pool Yard gates should be in place to separate Children from the Spa. Spas should not be placed near or
below Electrical or telephone cables. If there is not a dedicated 120 Volt receptacle within the 10 feet of your Spa,
contact a Licensed Electrician to supply power near the Spa. A GFCI Power Cord is supplied with all models. The
GFCI power Cord must be tested each use to insure proper operation. To test, simply depress the button marked
"TEST" on the GFCI Unit, the unit should stop operating and the reset button should appear. Push the reset button.
The unit should now operate normally. If the interrupter does not perform in this manner, a ground current is
following indicating the possibility of electric shock. Disconnect the power until the fault has been identified and
corrected.
Filling Your Spa
Check that your Spa's drain valve (located behind the Spas drain cover) is closed. With the electrical breaker in the
OFF position and/or the power cord un-plugged, fill to an approximate water level 0f 2" above the top of the
highest jet. Once the Spa is filled, power can then be supplied to your Spa. The Spa's heater will begin heating to
the temperature selected on your control panel. (See Spa Controller Instructions Attached)
Draining Your Spa
Unplug the Spa's electrical power supply. The Spa must remain unplugged until re-filled with water. Remove the
cap from the Spa's Drain hose and connect standard garden hose. Place the opposite end of the garden hose in the
drainage area and open the Spa's drain valve.
Adjusting Massage Jets
To adjust for direction, rotate the "eyeball" of the jet in the desired direction. To adjust for flow, turn the outer knob
clockwise to increase flow and counter clockwise to decrease flow. Do Not fully decrease flow to all of the jets at
the same time. This may cause your pump to malfunction and ultimately fail.
Air Adjustment
To introduce air into your Massage Jets, Turn the Air Adjustment Dials (located on the Spa's top edge). Adjust the
same as with the Massage Jets, clockwise to increase flow and counter clockwise to decrease flow.
Suction Fitting
Keep the suction fitting (located in the foot well area) of the Spa unobstructed and free from debris at all times. Do
not remove the suction-fitting screen while the Spa is connected to electrical power.
TS-100, TS-300, TS500
Selecting the right site for your new Spa
Advertisement
