Noise Boys Toys MIDImote Quick Start Manual

MIDImote Quick Start Guide
Version 1.0
December 2012
Introduction
The MIDImote is a programmable MIDI command
transmitter for use with MIDI enabled show control
systems and for remote control of MIDI equipped
hardware. Each key can be programmed to send a
single MIDI message on any desired channel with any
command data value(s). It can be bus powered from
compatible controllers or externally powered from a
wide range of power sources and adapters.
Power
The device can be powered through a fully connected
MIDI cable using Pin 1 (0V) and Pin 3 (5VDC) when
connected to a compatible host. Most MIDI enabled
equipment does not use these pins, only equipment
specifically developed to provide a regulated 5VDC
supply on these pins will provide bus power. Otherwise
an external power source can be connected to the DC
MIDI Out
socket on the rear of the device.
A wide range of power voltages, both AC and DC of
Power In
either polarity are supported. Virtually any power adapter
with an output of 8-20V and a minimum 75mA capability,
terminated in a 2.1mm DC plug will be suitable.
Programming
In order to enter programming mode, connect the power
source (or MIDI cable if bus powered) whilst holding the
blue button. Release the blue button when EDIT
COMMANDS is displayed. Values are changed and
accepted using the orange, blue and yellow buttons:
Orange - decrease
Blue - OK/next
Yellow - increase
Select Button
When programming mode is ready the device will display . Press the
button for which you wish to set/edit the MIDI command data. The current MIDI command
type will be first displayed. To select the type, use the orange (decrease) and yellow
(increase) buttons. Once the desired command type is displayed, press the blue (OK)
button to accept.
Cont...