Installation; Positioning; Start-Up; Before Starting Up For The First Time - Gastro-Cool Cool-Tool Instructions For Use Manual

7

Installation

7.1 Positioning

The appliance should be located in a well ventilated and dry room.
The ambient temperature affects the power consumption and correct
function of the appliance.
Sufficient air circulation on the rear wall and upper edge of the
appliance must be guaranteed. For optimal ventilation of the
appliance the minimum ventilation crossections must be observed:
i.e. position the refrigerator at least 10 cm away from the wall, and
furthermore a space of 2 cm must be left to the right and to the left,
and 30 cm mm at the top. If you wish to place the appliance on a
carpet, ensure that you use a solid and smooth base.
IMPoRTAnT
• The appliance must not be exposed to direct solar radiation.
• The appliance must not stand on heating elements, next to
a stove or other heat sources.
• The appliance must be positioned so that the mains plug
is accessible.
• The appliance may only stand in a location where the ambient
temperature corresponds to the climate classification for
which the appliance is designed.
The climate classification can be found on the identification plate
located on the outside of the appliance at the back. The table to
the side here shows which ambient temperature is assigned to which
climate classification:
SN 10 to 32°C
N 16 to 32°C
ST 18 to 38°C
T 18 to 43°C
28
8

Start-up

8.1 Before starting up for the first time
After transportation the appliance should be left to stand for at least
24 hours so that the refrigerant can collect in the compressor. Non-
observance of this may damage the compressor and so lead to the
appliance malfunctioning. In such a case the guarantee becomes invalid.
Clean the interior of the refrigerator and all of the accessories to be
found here with commercially available, mild cleaning products.

8.2 Connecting the appliance to the mains supply

IMPoRTAnT
It is imperative that the appliance be earthed according to
the directions. For this purpose the plug of the connecting
cable is provided with the appropriate contact.
IMPoRTAnT
Call a specialist electrician if the plug does not fit into the
socket. Do not try to force the plug into the socket.
IMPoRTAnT
If you disconnect the appliance from the mains supply, or
if a power cut occurs: wait for 5 minutes before you restart
the appliance.
29