Advertisement
Advertisement
Table of Contents
Summary of Contents for Twsit av stand
- Page 1 TWIST AV STAND product set up instructions 19968...
- Page 2 Twist AV Stand Setup Instructions...
- Page 3 Twist AV Stand Setup Instructions Place the AV base on the floor. Place a TWIST base over the AV base locating uprights and manoeuvre the TWIST base socket into position. WARNING: Please ensure orange screws are loosened fully before placing on the base, to prevent the screws resting on top of the locating uprights.
- Page 4 Twist AV Stand Setup Instructions Place the next section of AV upright onto the locating pin and slide a locking pin between the joint and tighten. Locate the AV crossbeam into position and tighten the locking pins.
- Page 5 TWIST upright sits behind the AV crossbeam. But dont hook the bottom of the graphic until the screen has been positioned on the AV Stand. Once you have attached the brackets provided to the TV/Monitor screen, manoeuvre the screen into position so that the two brackets sit on top of the crossbeam.
- Page 6 Twist AV Stand Setup Instructions The AV stand complete.
Need help?
Do you have a question about the av stand and is the answer not in the manual?
Questions and answers