Advertisement
To assemble your Body Bench simply follow the instructions. If further
assistance is needed, please call and we'll be glad to help.
1. Unpack all pieces and check to make sure that all are present.
2. Unfold the legs. Keep the nylocks tightened down to avoid the table
support bar from flipping backwards. Occasionally tighten the ¼"
nylocks.
3. Locate the two vacant ¼" holes in the front legs and insert a ¼" x 2
½" bolt through each followed by a flat washer. The washers serve as
spacers on which to pivot the tabletop.
4. Take the tabletop and line the two vacant ¼" holes up with the ¼" x 2
½" bolts you previously inserted in the legs. Insert the bolts through
the tabletop holes. Secure with two ¼" nylocks. Tighten to your
preference.
5. Your mobile Panel Bench is now assembled. The Detent Ringpin should
click into the hole in the leg when in the easel position. The tabletop
can be secured into "Table position" using the two latches on the table
support bar. The 3/8" rods can be conveniently stored in the table
support bar. Use the Adjustable Shelf Braces (6 – 28" & 6 – 18") by
simply interlocking the brackets onto the upright braces as needed.
6. Rod assembly: to make the plastic tubing easier to slide over the
3/8" rod, simply place a drop of oil or liquid soap inside the tubing.
Place the two rubber tips on the ends of the remaining 3/8" rods.
7. Wheel assembly: Bolt the 4" wheels to the outside of the front legs
using the 5/16" bolts and nuts provided.
8. The spoiler/bumper attachment slides into the tabletop and is
adjustable using the 2 knobs.
Auto Body Tool Mart is not responsible for accidents and/or damage due to
Assembly Instructions
****DISCLAIMER****
the misuse of this product.
Advertisement
