Table of Contents
Advertisement
AZURE
By HPI
Electricians make sure everything on this checklist is ticked off before you leave the installation site.
If you have trouble installing our product please refer to the trouble shooting section on the previous
page first then phone the Technical Advice Line on 1300 360 280 (open 9am to 5pm EST). DO NOT
uninstall the fan unless asked to do so.
Ceiling fan is not installed using a solid-state wall controller. Neither leading nor
lagging edge controllers will give satisfactory performance. Wall controllers must
1.
only be types approved for use with this fan.
2.
The fan, fan light assembly and bracket are earthed.
Fan, fan light and remote control receiver are run from the same final circuit via an
3.
isolation switch.
Mounting bracket must be firmly secured to a solid structure such as a concrete
ceiling, steel structure or timber framing. If additional bracing is added it must be
4.
firmly secured to the rafters and not left floating on the ceiling. Special mounts,
such as T-hooks, are available for certain types of installation.
Counter sunk screws are not to be used to attach bracket to ceiling.
5.
6.
Fan blades are at least 2.1m (7 feet) above floor level.
7.
Check the fan is operating correctly on all speeds.
If light is installed. Check light is functioning properly.
8.
If remote control is installed. Check the fan (and light if installed) is responding to
9.
the remote control correctly.
Check electrician's details have been recorded onto page 14 of this manual.
10.
1. Do not attempt to operate the fan (or light kit) with any wall control that is not approved by HPI for
use with its fans. DO NOT use solid state controllers. The use of unapproved controllers may void your
warranty.
2. Do not mix blade sets from one fan to another as this may upset the balance of the fan. If only one
blade is damaged you are still required to replace with a new set.
™
Quick Checklist
15
Installation &
User Manual
Advertisement
Table of Contents
