Advertisement
LENS REPLACEMENT AND INSTALLATION PROCEDURE
Perform the steps
1
REMOVE THE LENS COVER. (See figure-1)
Remove screws A (2 screws).
1.
Pull down the lower lens cover while pushing
2.
the part D, then remove it.
3.
Remove screws B (2 screws).
4.
Remove screws C (2 screws) and remove
upper lens cover.
2
● IN CASE OF MODEL WITHOUT LENS
REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2)
Remove 2 screws and pull down the plate.
(At the step
, insert the light-block sheet in the same
4
position as the removed cover plate has been placed.
Two screws are not used.)
Use the light-block sheet included with lens.
Set the light-block sheet, so that the large rounder side
is set over the lens.
● IN CASE OF MODEL WITH LENS
REMOVE THE LENS. (See figure-3.)
1. Remove the connector "K16B" of the
circuit board.
2. Loosen the A, B wire holder and
remove the lens motor lead.
3. Remove screws D (4 screws) which
fastens the lens and remove the lens.
1
to
4
for lens replacement and installation.
Set the light-block
sheet, so that the
large rounder side
is set over the lens.
UPPER LENS COVER
D
A
COVER PLATE
❋ Figure shown inside of the cabinet.
(D)
(D)
C
B
D
LOWER LENS COVER
SCREWS
LENS MOTOR
(D)
(D)
B
A
WIRE HOLDER
LENS MOTOR LEAD
CONNECTOR " K16B"
Fig-1
Fig-2
Fig-3
Advertisement
