Table of Contents
Advertisement
Display area
Selects the area displayed by this projector. Select the resolution at
the Display area dialog box.
Display area H
Adjustment of the horizontal area displayed by this projector. Press
the POINT LEFT/RIGHT button(s) to decrease/increase value and
then press the SELECT button.
Display area V
Adjustment of the vertical area displayed by this projector. Press the
POINT LEFT/RIGHT button(s) to decrease/increase value and then
press the SELECT button.
Full screen
When this function is on, SXGA image is fully displayed at 4 : 3
aspect ratio. It is displayed at 5 : 4 aspect ratio with this function off.
NOTE : The Full screen cannot be selected after the Display area,
Display area H, and Display area V are adjusted.
3
Store
To store adjustment parameters, move the red frame pointer to
the Store icon and then press the SELECT button. Move the red
arrow pointer to any of Mode 1 to 5 that you want to store to and
then press the SELECT button.
Mode free
To clear adjustment parameters previously set, move the red
frame pointer to Mode free icon and then press the SELECT
button. Move the red arrow pointer to the Mode that you want to
clear and then press the SELECT button.
Other icons operate as follows.
Reset
Reset all adjustment to their previous figure.
Quit
Closes the PC ADJUST MENU.
NOTE
G The Fine sync, Total dots, Display area (H/V), and Full screen
cannot be adjusted when "1035i (HDTV)" or "1080i (HDTV)" is
selected in the PC SYSTEM Menu (P23).
COMPUTER INPUT
Press the SELECT button at the
Display area icon and the Display
area dialog box appears.
Press the POINT LEFT
/RIGHT button(s) to adjust
value and then press the
SELECT button.
To store adjustment data.
This Mode has parameters being stored.
Vacant Mode
Shows values of "Total dots,"
"Horizontal," "Vertical," "Display
area H," and "Display area V."
To clear adjustment data.
Close this dialog box.
Display area
27
Advertisement
Table of Contents
