Installation - HighSecLabs HVS100 User Manual

Installation

Step 1 Connecting the Console devices to product

Connect the user display/s.

Connect the user keyboard

Connect the user mouse
Notes:
1. Console USB keyboard and mouse ports are switchable, i.e. you
can connect keyboard to mouse port and vice versa. However,
for optimal operation it is recommended to connect USB
keyboard to console USB keyboard port and USB mouse to
console USB mouse port.
2. For security reasons products do not support wireless keyboards.
In any case do not connect wireless keyboard to product.
3. Non-standard keyboards, such as keyboards with integrated USB
hubs and other USB-integrated devices, may not be fully
supported due to security policy. If they are supported, only
classical keyboard (HID) operation will be functional. It is
recommended to use standard USB keyboards.
4. Console USB mouse port supports Standard KVM Extender
composite device having a keyboard/mouse functions.
5. In any case do not connect a microphone to the switch audio
output port, including headsets.
Step 2 Connecting the Computers
Connect the computers to the Secure KVM Isolator through the
following steps:
11
Secure Isolator KVM User Manual

Connect each computer with KVM cable. USB cable can be
connected to any free USB port on the computer.
Note: If computer is having more than one video output connector –
first test for video output availability by connecting a display directly
to that port and then connect via the KVM Isolator.
Note: The USB cable must be connected directly to a free USB port
on the computer, with no USB hubs or other devices in between.

Connect an audio cable to the computer audio output (lime green
color) or line output (blue color) jacks.
Step 3 Power up

Power up user display. Select proper input if applicable (VGA or
DVI; DisplayPort).

Power up the Secure KVM Isolator by connecting DC power
supply. The display diagnostic LEDs should be solid green for a
few seconds after power up. This indicates the display EDID
information has been captured and secured. If the display
diagnostic LED remains blinking for longer than 10 seconds after
power up, refer to the Troubleshooting section of this user
manual.

Power up the connected computers.
Note: When you power on your computers, the Isolator emulates
both a mouse and keyboard to the connected PC and allows your
computer to boot normally. Check to see that the keyboard, display,
and mouse are working normally.
If you encounter an error, check your cable connections for that
computer and reboot. If the problem persists, please refer to the
Troubleshooting section in this User Manual.