Endon Equinox PIR Instruction Manual

Safety Warnings

This is a Class 1 product and must be earthed.
• Please read these instructions carefully before commencing any work, and retain for reference.
• Install in accordance with IEE Wiring regulations and current Building Regulations.
• To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other
persons cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult a
qualified electrician.
• This light fitting should be connected to a circuit with a 30mA RCD fitted.
• If replacing an existing fitting, make a careful note of the connections.
• This product contains non-replaceable LEDs. If the LEDs become damaged the unit must be disposed.
• Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
• This product is rated at IP44.
The shade must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the shade in place.

Care Information

Do not use solvents or abrasive cleaners as these could damage the finish. Do not clean the units with a
pressure washer.
In normal circumstances, stainless steel is very resistant to corrosion, but may require maintenance to preserve the
high quality appearance. Wash the product with warm soapy water, removing all surface deposits. Rinse with clear
water, and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation. This is normally caused by tiny iron particles left
behind after the brushing process when finishing. Wash and dry as detailed above, then with a soft cloth soaked
with a protective oil, wipe all over.
If the product is subject to extreme environmental conditions such as marine locations, industrial pollution, or acid
rain, these maintenance procedures should be carried out around four times a year. For severe corrosion, non-
abrasive cream cleaners or proprietary stainless steel cleaners should be used to remove the corrosion. Wash, dry
and coat with oil, as detailed above.
Plastic parts - Remove and wash in warm water or just use a damp cloth. Do not use abrasive materials as these
will damage the finish.

Assembly/ User Instructions

Check the packaging and make sure that you have all the required parts. Follow each assembly step in order to
prevent incorrect assembly. Ensure that the product is fully assembled as illustrated before use.
The Light pack contains:
Light fitting.
Terminal connection block(s).
Fixing pack.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Layout
• Plan the desired layout of this fitting carefully, ensuring the cables will reach the distance between the junction
box and the light fitting
• Avoid locating any cables in positions that would cause a hazard. Position cables and junction boxes (not
supplied) away from areas where they may be at risk from being cut, trapped or damaged
Endon Lighting, LS9 0SE
Equinox Outdoor Wall Light - PIR
INSTRUCTION MANUAL
Before you start
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
72916-EquinoxPIR-WB 20170621