Hisense RB17N6DWE User's Operation Manual page 16

Odours from the
compartments
Noise from the appliance
The motor runs
continuously
A layer of frost occurs in
the compartment
Temperature inside is
too warm
Temperature inside is
too cold
Doors can't be closed
easily
15
temperature to a colder level to solve this problem.
It is normal that the freezer is not operating during the defrost
cycle, or for a short time after the appliance is switched on to
protect the compressor.
The interior may need to be cleaned
Some food, containers or wrapping cause odours.
The sounds below are quite normal:
Compressor running noises.
Air movement noise from the small fan motor in the freezer
compartment or other compartments.
Gurgling sound similar to water boiling.
Popping noise during automatic defrosting.
Clicking noise before the compressor starts.
Clicking noise when you get the water.
The motor running noises when you get ice.
Other unusual noises are due to the reasons below and may
need you to check and take action:
The cabinet is not level.
The back of appliance is touching the wall.
Bottles or containers have fallen or are rolling.
It is normal to frequently hear the sound of the motor, it will
need to run more when in following circumstances:
Temperature setting is set colder than necessary
Large quantity of warm food has recently been stored within
the appliance.
The temperature outside the appliance is high.
Doors are kept open too long or too often.
After installing the appliance or it has been switched off for a
long time.
Check that the air outlets are not blocked by food and ensure
food is placed within the appliance to allow sufficient
ventilation. Ensure that door is fully closed. To remove the
frost, please refer to the
You may have left the doors open too long or too frequently; or
the doors are kept open by some obstacle; or the appliance is
located with insufficient clearance at the sides, back and top
Increase the temperature by following the "Display Controls"
chapter.
Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self-close, or if something inside
is preventing the doors from closing.
" C leaning and Care " chapter.