Niigata seiki INSIDE T CALIPERS User Manual

DIGITAL INSIDE POINT CALIPERS
INSIDE "T" CALIPERS
Thank you for purchasing the INSIDE "T" CALIPERS.
This product is a precision measurement tool designed specifically for point measurement of inside surfaces.
●For safe and proper use of this product, please read this instruction manual before use and follow the procedures described.
Please keep manual where it is accessible to user for future reference.
●Keep this manual with the instrument if transferred or leased to a third party.
●For inquiries about this product, please contact dealer or Niigata Seiki at the address listed on the following page.
■Part Identification and Description
④ Inside Jaw
② Outside Jaw
① Measuring Surface
For Outside Measurements
① Measuring Surface ...............
For Outside Measurements
② Outside Jaw ........................
③ Stylus Tip ...........................

Safety Precautions

Always follow the proper operating procedures in order to prevent
harm to yourself or others, and to prevent damage to property.
Caution
Indicates risk of personal injury or property damage if not followed.
Read the instruction manual and follow the
instructions.
・ Use of product other than as described in the manual
may cause accident.
Use only for measuring.
・ Use for any purpose other than measuring may damage
or wear the instrument. Improper use may also cause
accident.
Handle with Care.
・ Do not drop or subject instrument to excessive force. Do
not place under heavy objects. Improper handling may
cause damage or poor accuracy.
・ Do not scratch instrument.
Avoid using in locations with high electric fields,
such as near fluorescent lights or switching power
supplies.
・
May cause erroneous reading to display on LCD.
③ Stylus Tips
⑧ [ HOLD ] Button
⑤ Lock Screw
⑥ LCD Display
⑩ [ ON/ZERO ]
Button
⑨ [ SET ] Button
Outside measurements performed
between these surfaces.
For external measurements.
Applied to inside surfaces for
measurement.
Please Observe
⑦ Battery Cover
④ Inside Jaw ......................
⑤ Lock Screw ....................
⑥ LCD Display ...................
⑦ Battery Cover ..............
⑧ [ HOLD ] Button ...............
⑨ [ SET ] Button ..................
⑩ [ ON/ZERO ] Button ...........
⑪ Scale ..............................
Denotes a "prohibition":
You MUST NOT do it.
Use and store only in environment meeting the
following conditions.
●Dry location protected from rain, water, and oils.
●Location that does not become hot.
●Location protected from use by children and
unauthorized people.
Use in places contrary to the above may cause
・
damage to the product resulting in accident or injury.
Jaw Tips Are Sharp -- Handle With Care.
・
Careless handling may cause injury.
Do not disassemble or modify.
・
Doing so may cause accident or injury. Please contact
distributor or place of purchase for service.
Do not write on instrument with electric engraver.
Do not engrave instrument or jaw, such as an ID
・
number with engraver or electric pen.
User Manual
D-150IT
Model No.
⑪ Scale
For internal measurements.
Locks the slide unit and LCD.
Digitally displays the measured value.
Cover for Silver Oxide SR44 battery.
Holds value on display.
Switch to Preset Mode.
Power ON/OFF, will display preset value.
Measurement reference for LCD slide.
Denotes a "requirement":
You MUST do it.