Hanh Filtration HF-SH Installation Instructions

Performance Data for the HAHN Premium Shower Filter HF-SH
Model Replacement Operating pressure range
HF-SH HF-SH-R 50 psi
Manufactured by: Sink Warehouse, LP • 4601 Spicewood Springs Rd., Suite 1-100 • Austin, Texas 78759 • (888) 245-3114
This system has been tested according to NSF/ANSI 177 for reduction of free available chlorine. The
concentration of free available chlorine in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI
177. This system has not been evaluated for free available chlorine reduction performance in the
presence of chloramines. Free available chlorine reduction performance may be impacted by the
presence of chloramines in the water supply. Please contact your local water utility to determine if
chloramines are used in treating your water.
The HF-SH Water Filtration System filter cartridge should be replaced every six months
to ensure peak performance.
This filter system is designed and tested for use with genuine Hahn Filtration parts,
including replacement filters and all hardware. Use of parts from other manufacturers
may result in loss of contaminant reduction performance, system damage or failure.
Use of parts from other manufacturers will also void your warranty. Please visit
hahnfiltration.com for all replacement parts.
Testing was performed under standard laboratory conditions, acutal performance may
vary. See preceeding page for general installation conditions and needs.
The Hahn shower filtration system is designed to produce the highest quality water
possible with the least amount of pressure loss. Hahn's patented two-stage filter
cartridge substantially reduces chlorine and other chemicals present in tap water.
In compliance with California State Law, this system has a maximum flow rate of 2
gallons per minute. The Hahn adjustable shower head can be adjusted to the desired
pressure while still conserving water usage. The filter cartridge should be replaced
every six months per instructions.
• Do not use with water that is microbiologically unsafe or of unknown
water quality without adequate disinfection before or after the system.
• This system and installation shall comply with applicable state and local regulations.
• This system is not for use as a drinking water treatment unit.
Manufactured by Sink Warehouse, LP
4601 Spicewood Springs Rd, Suite 1-100, Austin, Texas 78759
(888) 245-3114
Rated capacity Max operating temp Rated flow
10,000 gallons 115° F 2.0 gpm
www.hahnfiltration.com
•
HF-RO3-RM_OM_201403
Premium Shower Filter

Installation Instructions

MODEL HF-SH