Advertisement
Quick Links
What your pole package contains:
1 Xtreme Pole (18, 22, 25, 35 or 47)
1 Gooseneck
1 Hose Pack & Connector
1 Brush of choice
To assemble your pole ready for use:
Remove any packaging and carriage straps.
Slide non-connector end of pole hose up though the base of the Xtreme pole
and push through until it appears out the top of the pole.
Connect the pole hose to the straight connector on the Gooseneck/Brush
assembly—push firmly on.
Open the top clamp and slide the gooseneck fully into the top section. Close
the top clamp lever (adjust if needed) so that it firmly holds the gooseneck in
position.
Connect the pole hose connector to your hose reel and the pole is ready for
work.
Advertisement
Summary of Contents for Gardiner Xtreme series
- Page 1 What your pole package contains: 1 Xtreme Pole (18, 22, 25, 35 or 47) 1 Gooseneck 1 Hose Pack & Connector 1 Brush of choice To assemble your pole ready for use: Remove any packaging and carriage straps. Slide non-connector end of pole hose up though the base of the Xtreme pole and push through until it appears out the top of the pole.
- Page 2 Using the Pole with Extensions With the Xtreme range of poles there also various types of Extension sections available. The Xtreme18, 22 and 25 both have the option of an extra single extension section. The 22ft, 25ft and 35ft also have the option of a two-section Xtreme extension pack.
- Page 3 Fitting Extensions to the Xtreme44 & 47 The Xtreme44 & 47 have the option of being used with modular clamped ex- tension sections or the #10-12 triple telescopic extension pack if needed for high level work. Standard Extensions—For use up to 64ft—3 extensions maximum #10-12 Triple Telescopic Extension Pack—1 pack per pole Hi-Strength Extensions—For use up to 79.5ft—6 extensions maximum We do not recommend mixing these extension sections in use on the pole.
- Page 4 Fitting subsequent Modular sections. To do this you have two options: Fit extra extension sections by sliding the extension over the end of the pole hose (disconnect from hose reel or tap first). Slide extension on to the stepped base of the extension section above and clamp in the fully inserted position.
- Page 5 Brush compatibility – if using this pole with your own choice of brush, we would recommend that you do not fit a brush weighing more than 300g. Do not use this pole with the Gardiner Super-Lite or Supreme 45cm brushes as they are too heavy for these poles.
-
Page 6: Warranty
POLE MAINTENANCE Cleaning Schedule: Keep the pole as clean as possible at all times. Wiping the pole hose after each use will reduce the amount of dirt entering the pole. A wipe with a cloth as you are coiling the hose away is sufficient. Hose the pole down once a week or after working in gritty or sandy envi- ronments.