Download Print this page

SuspensionMAXX SMX-GM725M Installation Instructions

Fits: chevrolet/gmc 2007-2016 silverado/sierra/suburban/tahoe 1500 4wd/2wd/awd

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS
PART#: SMX-GM725/GM725M
FITS: Chevrolet/GMC
•2007-2016 Silverado/Sierra/Suburban/Tahoe
1500 4WD/2WD/AWD
Thank you for choosing SuspensionMaxx for your
vehicle. This kit is designed to add
and increase front and ground clearance. Specially
designed tools and experience are required to complete
the installation properly. These parts should only be
installed by a qualified mechanic otherwise an unsafe
vehicle and/or injury may result. Consult manufactures
service manual for proper torque specifications and
procedures. Instructions are supplied for the leveling kit
installation only. Safety is important. Use safe working
habits.
WARNING!
This suspension system will enhance off road performance and increase
ground clearance. Larger tires will increase vehicle roll center height.
The vehicle will handle and respond to driver steering and braking dif-
ferently from a stock factory equipped passenger car or truck. Extreme
care must be used to prevent loss of control or vehicle rollover during
abrupt maneuvers both on and off-road. Failure to operate this vehicle
safely can result in vehicle damage, serious injury or death to the driver
and passengers. Always wear your seat belt and reduce your speed,
avoid sharp turns, inclines and abrupt maneuvers. Tread lightly, re-
spect nature and enjoy the Off-Road Experience! Help keep it available
for future generations.
Thank You!
SuspensionMAXX Inc.
suspension travel
INSTRUCTIONS
SuspensionMAXX kits are designed to be easily installed
and completely reversible to the factory supplied settings.
These instructions are supplied for ease of installation,
correct procedures and safety. Automotive experience
recommended.
REQUIRED TOOLS
Load-rated floor jack
Safety stands x2
Wheel Chocks
Metric tool set
Torque Wrench
Loctite threadlocker for all fasteners

Advertisement

loading
Need help?

Need help?

Do you have a question about the SMX-GM725M and is the answer not in the manual?

Questions and answers

Summary of Contents for SuspensionMAXX SMX-GM725M

  • Page 1 •2007-2016 Silverado/Sierra/Suburban/Tahoe 1500 4WD/2WD/AWD INSTRUCTIONS Thank you for choosing SuspensionMaxx for your SuspensionMAXX kits are designed to be easily installed vehicle. This kit is designed to add suspension travel and completely reversible to the factory supplied settings. and increase front and ground clearance. Specially...
  • Page 2 STEP 1: Removal STEP 1: Removal (Continued) 1. Jack and support front of vehicle under frame with 7. View upper strut frame tower. NOTICE: Wire loom attachment clip locations. Pry closely load rated jack stands. (Allow the suspension to upward on plastic retainers to free from mounting stud relax fully by supporting the frame) threads, as these will be reused later.
  • Page 3 Strut arm allowing for Mount Extender. side facing up. “SUSPENSIONMAXX” installation of NOTICE: Use EXTREME Caution during the step above, the Strut Mount closely monitor ABS wire and CV Axel clearances to prevent Extender.
  • Page 4 9. Reinstall ABS wire into A-Arm Clip. 10. Torque upper 3 strut mount nuts to 25ft/lbs. 11. Reinstall wire loom clips. 12. Install wheels. 13. Perform wheel alignment to specifications below. WHEEL ALIGNMENT SPECS W/ LEVELING KIT CAMBER 0.5Deg. +/- 0.5Deg. CASTER 2.0Deg.

This manual is also suitable for:

Smx-gm725