Introduction The ND-70M-HDBT-HVD is multi-format switcher with HDMI, VGA and Display Port inputs to HDBT output. The audio port is independent and could be embedded into any of the video signal and send it to the far end. The product support web server and it could be controlled by the button, lan, Rs232, contact closure, IR and Rs232 can pass through.
Panel Description Front Panel 1. PWR: Solid red when power on; 2. HDMI: Led solid when with HDCP, flashing when without HDCP; 3. Link: flashing when HDBT connected without video signal, solid when video presented; 4. D:LED solid when DP selected, flashing when signal presented, off mean no input signal; 5.
Connection and Installation Specification Video HDMI Compliance HDMI 1.4, 3D, 4K VGA Compliance VESA DP Compliance DP 1.2 HDCP Compliant HDCP 1.4 Distance Up to 70m Max Resolution Up to 4K x 2K@30Hz Control Control RS232,IP,IR, Contact Closure Mechanical Dimensions 190 x103 x 29 mm (L/W/H) Gross Weight 880g...
IP property to static IP as below. Once done, open a web brower and enter the 192.168.2.175 to access to the web server. For the ND-70M-HDBT-HVD connected to the local area network, please update the ND-70M-HDBT- HVD product IP to match the lan network setting from the web server.
Input/Output Config The page provided the switching and also the connection input signal information and hdbt output connection status. AV Inputs – Select to switch the input Auto Switch Video – If check, the device is set in auto switching mode else in manual mode External Audio –...
EDID Management The page provided switching and EDID management. this page. Follow Output – EDID from Display Network Devices – Internal Preload EDID...
Page 8
Rs232 Config Rs232 –Local Rs232 setting to control the MVE-HPV HDBT Rs232 – Set the far end Rs232 baud rate. Rs232 Preset Command1 – When detect active signal, send the Rs232 command in the preset timing Command2 – When no active signal present, send the command in the preset timing Button –...
Page 9
System System and fw info. User could modify the IP setting on the page. Please remember to click on Apply for the changes.
This warranty shall be void if a serial number has been removed from the product. Upon determination of a legitimate defect covered by this warranty and at Network Devices sole discretion, user should bear the transport cost during the warranty.