Removing Door - Sanyo EM-842WS Service Manual Supplement

H. H. REMOVING DOOR H. H. H.

REMOVING DOOR

REMOVING DOOR REMOVING DOOR REMOVING DOOR
(1) Remove 2 hex nuts securing the upper hinge.
(2) Tilt the top of the Door toward you.
(3) Lift up the Door to remove it.
- After replacing the Door, be sure to check that the
Primary Interlock Switch, the Door Sensing Switch
and the Interlock Monitor Switch operate normally.
(See page 1).
- After replacing the Door, check for microwave energy
leakage with a leakage detector. Microwave energy
leakage must be below the limit of 4mW/cm
allow for measurement uncertainty.
I. I. I. I. I. DISASSEMBLING DOOR DISASSEMBLING DOOR DISASSEMBLING DOOR DISASSEMBLING DOOR DISASSEMBLING DOOR
(Figure 15)
(1) Insert a thin flat-blade screwdriver between the
Choke Dielectric and the Door Main Frame and lift
up the Choke Dielectric to release hooks one by
one. (Figure 15).
(2) Remove the Choke Dielectric.
(3) To detach the Door Cover, insert a thin flat-blade
screwdriver between Door Cover and Door Panel
and release the projections inside Door Cover.
(4) To detach the Door panel, insert a thin flat-blade
screwdriver between the Door Cover and Door
Main Frame.
Hooks
Door
Main
Frame
Choke
Dielectric
- The Choke Dielectric may be damaged when
it is removed. When reinstalling it replace it
with new ones if it is damaged.
- After installing the Door in place, check for
microwave energy leakage with a detector.
Microwave energy leakage must be below the
limit of 4mW/cm
uncertainty.
NOTE NOTE NOTE NOTE NOTE
Hooks
Hooks
Hooks
Figure 15 Figure 15 Figure 15 Figure 15 Figure 15
NOTE NOTE NOTE
NOTE NOTE
2
to allow for measurement
J. J. J. J. J. REMOVING CA REMOVING CA REMOVING CA
REMOVING CA REMOVING CAVITY COVER
(Figure 16)
(1) Remove a screw from the Cavity compartment.
Cavity Cover
2 to
Screw
K. K. K. K. K. REMOVING TURNT REMOVING TURNT REMOVING TURNT
REMOVING TURNT REMOVING TURNTABLE MOTOR COVER
(Figure 17)
(1) Turn over the oven on its back.
(2) Cut the 6-joints of the Bottom Plate using diagonal
pliers (nipper).
(3) Separate the Motor Cover from Bottom Plate.
(4) Remove 2 screws securing Turntable Motor to the
Cavity and take it out.
Note Note Note : Bent the cut joints inside slightly for safety Note Note
- 14 -
VITY COVER VITY COVER
VITY COVER VITY COVER
Figure 16 Figure 16 Figure 16 Figure 16 Figure 16
ABLE MOTOR COVER ABLE MOTOR COVER
ABLE MOTOR COVER ABLE MOTOR COVER
and be careful of sharp edge.
Motor Cover
6 Joints
Bottom Plate
Figure 17 Figure 17 Figure 17 Figure 17 Figure 17