Summary of Contents for JC-Tool JC-4200-WM
- Page 1 JC MACHINERY & TOOLS INC. Quality We Trust Roof Waterproofing Membrane Welding Machine JC-4200-WM User Manual _____________________________________________________________________ www.jc-tool.com info@jc-tool.com...
- Page 2 7. Don’t use welder in the water, or on a muddy construction site, to avoid flooding, rain or moisture. iii. Technical Parameters Voltage Frequency 50/60 power 4200 Temperature 50～620℃ (122～1148℉) ＜7.8 Welding speed m/min Welding width Size( LxWxH) 555x358x300 Weight __________________________________________________________________ www.jc-tool.com info@jc-tool.com...
- Page 3 Clump weight ( outer) blower blower Guide bar Belt wheel fixed screw Baffle of micro switch Handle Rolling wheel adjusting screw Position handle of hot Moving switch Round belt air blower ON/OFF switch Belt wheel Casing cover __________________________________________________________________ www.jc-tool.com info@jc-tool.com...
- Page 4 ● When the welder starts to move, the LCD display shows as Figure 3. Current speed Current temp. Setting speed Setting temp. Figure1 Current temp. Current speed Setting temp. Setting speed Figure 2 Current temp. Current speed Setting temp. Setting speed Figure 3 __________________________________________________________________ www.jc-tool.com info@jc-tool.com...
- Page 5 (33) to right side until the right position of limit groove plate of guide wheel (32), to keep the guide wheel (29) in the same alignment with the edge of upper film. Upper film Down film The edge of upper film Figure 4 __________________________________________________________________ www.jc-tool.com info@jc-tool.com...
- Page 6 7. After finish the welding job, press the Temperature setting knob+ and Temperature setting knob- to make the hot air blower in a cold blowing condition in order to cool the nozzle. 8. Last step is to off the power. __________________________________________________________________ www.jc-tool.com info@jc-tool.com...
- Page 7 (7) ( by adjusting the screw under the roller is not right fixed set of hot air blower) X. Routine Maintenance Use steel brush to clean the hot air nozzle Clean the air inlet at the back of the hot air blower __________________________________________________________________ www.jc-tool.com info@jc-tool.com...