Abode RF User Manual

Indoor siren

Table of Contents

Download this manual

abode Indoor Siren (abode RF)

Siren - User Guide

Introduction

The abode indoor siren is AC Powered with a rechargeable battery. It is capable of sounding its 95dB siren

when the abode alarm system is activated. It can be plugged into any indoor AC power outlet.

1. Function Button/LED Indicator

• Press and hold for 10 seconds to enter the pairing mode when learning it into the gateway.

• LED flashes once: When the button is pressed

• LED continuous flash: The Siren is under pairing mode or the system is in the alarming mode

2. Alarm Volume and entry exit beep sounds (Refer to page 4 & 5)

• Alarm siren volume: Is not adjustable

• Entry / Exit / Arm / Home Arm / Disarm (These Sounds (Beeps) are defaulted to OFF. User

controllable from web app, under the account tab on the left / system settings.

3. AC Connect (Plug into local wall AC outlet)

The Siren is powered by AC power; plug the Siren into a power outlet to activate the Siren. The Siren will

enter normal operation mode.

There is a rechargeable battery inside the Siren that serves as a backup in case of a power failure. During

normal operation, AC power is used to power the Siren and at the same time recharge its battery.

After AC power failure, the battery will provide power to the siren for 12 hours, then transmit a Low Battery

signal to the gateway and send notifications. After AC is restored and battery is fully recharged, the Siren will

transmit a low battery restored notification to the gateway.

abode Systems Inc. Visit our support page for more information

abode reserves the right to update this product information at any time without notice.

http://support.goabode.com/

2016

Table of Contents

Do you have a question about the RF and is the answer not in the manual?

Page 1 Siren - User Guide Introduction The abode indoor siren is AC Powered with a rechargeable battery. It is capable of sounding its 95dB siren when the abode alarm system is activated. It can be plugged into any indoor AC power outlet.
Page 2 Pairing the Siren with the Gateway When adding the siren to your gateway, you will need to use the abode web app. Log into your account at www.my.goabode.com and follow the three steps below. Then click on Other Devices. This will open the paring...
Page 3 Chime sounds. abode Systems Inc. Visit our support page for more information http://support.goabode.com/ 2016 abode reserves the right to update this product information at any time without notice.
Page 4 (Based on the number of seconds set) abode Systems Inc. Visit our support page for more information http://support.goabode.com/ 2016 abode reserves the right to update this product information at any time without notice.
Page 5 The siren can be reset and memory contents cleared by following steps: Step 1: Delete the Siren from the gateway by using the abode web app at my.goabode.com. Step 2: Remove the Siren from installed power AC outlet...